Courseiva
← Back to certifications

Cisco certification practice

200-301 CCNA 200-301 practice test

Use this page to practise 200-301 CCNA 200-301 practice test. The goal is not to memorise dumps, but to understand the concept, review the explanation and improve your exam readiness. Cisco exams often test practical networking judgement: reading command output, interpreting topologies, and choosing the right configuration or troubleshooting step. Courseiva focuses on original exam-style practice questions with explanations, not copied exam dumps.

Start practiceBrowse exam questions
1,052
practice questions
Mapped
exam topics
200-301
exam code
Cisco
vendor
Last reviewed: May 2026 · aligned to official blueprint

Exam guide

How to use this 200-301 practice test

Start with a short practice session, review each missed answer, then return to the topics that caused mistakes.

Quick answer

Routing questions usually test route selection (administrative distance, metric), how static routes are configured and when they are preferred over dynamic routing.

Administrative distance comparing routing sources.

Static route configuration: next-hop vs exit interface.

Default route propagation and the gateway of last resort.

Recursive routing table lookups.

Related practice questions

Focused 200-301 topic practice pages

Use these internal links to move from the exam guide into focused topic practice pages.

CCNA subnetting practice questions

Practise IPv4 subnetting, CIDR, masks, host ranges and subnet selection.

CCNA OSPF practice questions

Practise OSPF neighbours, router IDs, metrics, areas and routing-table interpretation.

CCNA VLAN practice questions

Practise VLANs, access ports, trunks, allowed VLANs and switching scenarios.

CCNA STP practice questions

Practise spanning tree, root bridge election, port roles and STP troubleshooting.

CCNA EtherChannel practice questions

Practise LACP, PAgP, port-channel behaviour and bundle requirements.

CCNA ACL practice questions

Practise standard and extended ACLs, permit/deny logic and traffic filtering.

CCNA NAT practice questions

Practise static NAT, dynamic NAT, PAT and inside/outside address translation.

CCNA DHCP practice questions

Practise DHCP scopes, relay, leases and troubleshooting.

CCNA show ip route practice questions

Practise routing-table output, longest-prefix match, AD and route selection.

CCNA show interfaces trunk practice questions

Practise trunk verification and VLAN forwarding across switches.

CCNA wireless security practice questions

Practise WLAN security, authentication and wireless architecture concepts.

CCNA IPv6 practice questions

Practise IPv6 addressing, routes, neighbour discovery and common IPv6 exam traps.

Sample questions from this exam

Question 1mediummultiple choice
Full question →

A router learns the same prefix from both OSPF and EIGRP. Which route is installed by default?

Full question →
Question 2mediummultiple choice
Full question →

A router has routes for 10.10.0.0/16, 10.10.20.0/24, and a default route. Which route is used for destination 10.10.20.55?

Full question →
Question 3hardmultiple choice
Full question →

A router shows this output:

R1#show ip ospf neighbor
Neighbor ID     Pri   State           Dead Time   Address         Interface
10.1.1.2          1   FULL/DR         00:00:34    192.168.12.2    GigabitEthernet0/0
10.1.1.3          1   2WAY/DROTHER    00:00:39    192.168.12.3    GigabitEthernet0/0

Which statement is correct?

Full question →
Question 4hardmultiple choice
Full question →

A non-root switch has two uplinks toward the root bridge. One path has a lower total STP cost than the other. What role will the lower-cost uplink have?

Full question →
Question 6hardmultiple choice
Full question →

A router interface applies this ACL inbound:

10 deny tcp any any eq 80

20 permit ip any any

A user reports that web browsing to a server by IP address fails, but ping works. Which statement best explains the behavior?

Full question →
Free 200-301 CCNA 200-301 Practice Test | Courseiva | Courseiva