Refer to the exhibit. An administrator is troubleshooting a link between two switches. The status shows 'up' but the protocol is 'down'. What is the most likely cause?
Exhibit
SW1# show ip interface brief Interface IP-Address OK? Method Status Protocol FastEthernet0/1 unassigned YES unset up down
Trap 1: The cable is unplugged
If the cable were unplugged, the status would be 'down' and the protocol would be 'down'. The 'up/down' state confirms that the physical layer is active and receiving a signal, meaning the cable is connected, but the logical link layer is failing to communicate.
Trap 2: The port is administratively shut down
An administratively shut down port will display 'administratively down' for both the status and the protocol. Because the interface status is 'up', the port has been enabled via the 'no shutdown' command, confirming that the issue is logical rather than an administrative status problem.
Trap 3: The IP address is not configured
Layer 2 connectivity for switches does not require an IP address on the physical interface to maintain a line protocol state. While an SVI needs an IP for management, the physical port will reach an 'up/up' state regardless of IP assignment as long as frames are processed.
- A
The cable is unplugged
Why it fails: If the cable were unplugged, the status would be 'down' and the protocol would be 'down'. The 'up/down' state confirms that the physical layer is active and receiving a signal, meaning the cable is connected, but the logical link layer is failing to communicate.
- B
Layer 2 configuration mismatch
The up/down state indicates a Layer 2 protocol failure. Common causes include mismatched encapsulation types on trunk ports or native VLAN mismatches, which prevent the switches from correctly interpreting the frames being sent across the physical link, keeping the line protocol in a down state.
- C
The port is administratively shut down
Why it fails: An administratively shut down port will display 'administratively down' for both the status and the protocol. Because the interface status is 'up', the port has been enabled via the 'no shutdown' command, confirming that the issue is logical rather than an administrative status problem.
- D
The IP address is not configured
Why it fails: Layer 2 connectivity for switches does not require an IP address on the physical interface to maintain a line protocol state. While an SVI needs an IP for management, the physical port will reach an 'up/up' state regardless of IP assignment as long as frames are processed.