Question 1mediummultiple choice
Full question →mediummultiple choiceObjective-mapped
A network administrator is configuring a trunk port between two switches. Both switches have been set with native VLAN 99. However, traffic from some VLANs is not passing over the trunk. What should the administrator verify?
Answer choices
Why each option matters
Good practice is not just finding the correct option. The wrong answers often show the exact trap the exam wants you to fall into.
A
Distractor review
The VTP domain name matches on both switches.
VTP is not required for trunking, and mismatched VTP domains do not prevent trunk traffic.
B
Best answer
The allowed VLAN list on the trunk port.
By default, trunk ports allow all VLANs, but administrators sometimes restrict the allowed VLAN list. If a VLAN is not in the allowed list, its traffic will not pass.
C
Distractor review
The speed and duplex settings are identical.
Speed/duplex mismatches can cause issues, but they would affect all traffic, not just specific VLANs.
D
Distractor review
The spanning tree protocol is disabled.
Spanning tree should be enabled to prevent loops; disabling it could cause issues but not selective VLAN blockage.
Common exam trap
Common exam trap: an active trunk can still block the VLAN you need
A trunk being up does not prove every VLAN is crossing it. Check allowed VLAN lists, native VLAN mismatch, VLAN existence and access-port assignment.
Technical deep dive
How to think about this question
VLAN questions usually combine access-port and trunking clues. The key is to identify whether the issue is local to one switchport, caused by the trunk, or caused by the VLAN not existing where it needs to exist.
KKey Concepts to Remember
- Access ports place end devices into a single VLAN.
- Trunk ports carry multiple VLANs between switches.
- Allowed VLAN lists decide which VLANs can cross a trunk.
- Native VLAN mismatch can create confusing symptoms.
TExam Day Tips
- Use show vlan brief to verify access VLANs.
- Use show interfaces trunk to verify trunk state and allowed VLANs.
- Do not treat every same-VLAN issue as a routing problem.
Related practice questions
Related N10-009 practice-question pages
Use these pages to review the topic behind this question. This is how one missed question becomes focused revision.
Network+ network fundamentals practice questions
Practise N10-009 questions linked to Network+ network fundamentals.
Network+ implementation practice questions
Practise N10-009 questions linked to Network+ implementation.
Network+ operations practice questions
Practise N10-009 questions linked to Network+ operations.
Network+ security practice questions
Practise N10-009 questions linked to Network+ security.
Network+ troubleshooting practice questions
Practise N10-009 questions linked to Network+ troubleshooting.
More questions from this exam
Keep practising from the same exam bank, or move into a focused topic page if this question exposed a weak area.
Question 1
A network engineer needs to connect two switches located 400 meters apart. The cable run includes high electromagnetic interference from nearby machinery. The engineer decides to use fiber optic cabling. Which transceiver type and fiber combination should be used to ensure the link reaches 400 meters while remaining cost-effective?
Question 2
A network engineer is designing a new switched network and needs to ensure that broadcast traffic from one department does not reach another department's workstations. The engineer plans to use VLANs. Which of the following must be configured on the switches to isolate broadcast domains as intended?
Question 3
A security engineer is configuring a site-to-site VPN between two branch offices. The requirement is to encrypt all traffic between the two networks using IPsec. Which IPsec mode should be used to encrypt the entire IP packet including the original header?
Question 4
A network administrator is connecting two switches to increase bandwidth and provide redundancy. Which technology should be used to combine multiple physical links into a single logical link?
Question 5
A network administrator is experiencing issues where unauthorized devices are offering IP addresses to clients, causing connectivity problems. Which security feature should be enabled on switches to prevent this?
Question 6
A network administrator is troubleshooting a connectivity issue and suspects the problem is related to the physical cabling. At which layer of the OSI model should the administrator begin their investigation?
FAQ
Questions learners often ask
What does this N10-009 question test?
Access ports place end devices into a single VLAN.
What is the correct answer to this question?
The correct answer is: The allowed VLAN list on the trunk port. — When trunking, the allowed VLAN list determines which VLANs are carried over the trunk. By default, all VLANs are allowed, but an administrator may have restricted the list. If a VLAN is not in the allowed list, its traffic will not pass. The other options are less likely: VTP domain mismatch doesn't block traffic, speed/duplex issues would affect all traffic, and disabling spanning tree could cause loops but not selective VLAN blocking.
What should I do if I get this N10-009 question wrong?
Then try more questions from the same exam bank and focus on understanding why the wrong options are tempting.
Discussion
Loading comments…
Sign in to join the discussion.