- A
The packet is permitted because the ACL matches and uRPF is not applied.
Why wrong: uRPF is applied; both ACL and uRPF must pass.
- B
The packet is dropped by uRPF because strict mode requires the source to be reachable via the receiving interface.
Strict uRPF (rx) fails because the return route uses a different interface.
- C
The packet is dropped by the ACL because the deny statement blocks all traffic.
Why wrong: The permit statement matches the source prefix, so the ACL permits the packet.
- D
The packet is permitted because uRPF only checks destination addresses.
Why wrong: uRPF checks the source address, not the destination.
Question 1,080 of 2,152
300-410 IPv6 Traffic Filtering and uRPF Practice Question
This 300-410 practice question tests your understanding of ipv6 traffic filtering and urpf. The scenario asks you to isolate a root cause — eliminate options that address a different problem before choosing. After answering, compare your reasoning against the explanation and wrong-answer breakdown below. Once you have made your selection, read the full explanation to reinforce the concept and understand why each distractor is designed to mislead on exam day.
Consider the following configuration:
ipv6 access-list FILTER
permit ipv6 2001:db8:3::/48 any deny ipv6 any any interface GigabitEthernet0/5
ipv6 traffic-filter FILTER in ipv6 verify unicast source reachable-via rx
A packet arrives on GigabitEthernet0/5 with source 2001:db8:3::100 and destination 2001:db8:4::1. The route for 2001:db8:3::/48 points out interface GigabitEthernet0/6. What happens?
Answer choices
Why each option matters
Answer the question above first, then reveal the full breakdown to understand why each option is right or wrong.
Correct answer & explanation
✓
The packet is dropped by uRPF because strict mode requires the source to be reachable via the receiving interface.
The packet is dropped by uRPF (unicast Reverse Path Forwarding) in strict mode because the `ipv6 verify unicast source reachable-via rx` command checks that the source address 2001:db8:3::100 is reachable via the receiving interface (GigabitEthernet0/5). The route for the source prefix 2001:db8:3::48 points out GigabitEthernet0/6, not the receiving interface, so uRPF fails and drops the packet before the ACL is evaluated.
Key principle: Answer the scenario, not the keyword: identify the specific constraint before choosing the most familiar-sounding option.
Answer analysis
Option-by-option breakdown
For each option: why learners choose it and why it is or isn't the right answer here.
- ✗
The packet is permitted because the ACL matches and uRPF is not applied.
Why it's wrong here
uRPF is applied; both ACL and uRPF must pass.
- ✓
The packet is dropped by uRPF because strict mode requires the source to be reachable via the receiving interface.
Why this is correct
Strict uRPF (rx) fails because the return route uses a different interface.
Related concept
Read the scenario before looking for a memorised answer.
- ✗
The packet is dropped by the ACL because the deny statement blocks all traffic.
Why it's wrong here
The permit statement matches the source prefix, so the ACL permits the packet.
- ✗
The packet is permitted because uRPF only checks destination addresses.
Why it's wrong here
uRPF checks the source address, not the destination.
Common exam traps
Common exam trap: answer the scenario, not the keyword
Cisco often tests the order of operations: uRPF is checked before ACLs, so candidates mistakenly think the ACL permit will allow the packet, but uRPF drops it first.
Detailed technical explanation
How to think about this question
The `ipv6 verify unicast source reachable-via rx` command implements strict uRPF as defined in RFC 3704, which requires the source address to have a route pointing back to the same interface on which the packet arrived. In this scenario, the route for 2001:db8:3::/48 points to GigabitEthernet0/6, so the check fails. Note that uRPF processing occurs before ACL evaluation in the ingress path, so a uRPF failure drops the packet without consulting the ACL.
KKey Concepts to Remember
- Read the scenario before looking for a memorised answer.
- Find the constraint that changes the correct option.
- Eliminate answers that are true in general but not in this case.
TExam Day Tips
- Watch for words such as best, first, most likely and least administrative effort.
- Review why wrong options are wrong, not only why the correct option is correct.
Key takeaway
Answer the scenario, not the keyword: identify the specific constraint before choosing the most familiar-sounding option.
Real-world example
How this comes up in practice
A security administrator must allow nursing staff to reach a patient records server while blocking access from the guest Wi-Fi VLAN. After applying an extended ACL, traffic is still blocked from nursing workstations. The ACL was applied outbound instead of inbound on the wrong interface. Questions like this test ACL direction and placement rules.
Visual reference
What to study next
Got this wrong? Here's your next step.
Identify which exam domain this question belongs to, review the core concept, then practise similar questions from the same domain.
- →
IPv6 Traffic Filtering and uRPF — study guide chapter
Learn the concepts, then practise the questions
- →
IPv6 Traffic Filtering and uRPF practice questions
Targeted practice on this topic area only
- →
All 300-410 questions
2,152 questions across all exam domains
- →
Cisco CCNP ENARSI 300-410 study guide
Full concept coverage aligned to exam objectives
- →
300-410 practice test guide
How to use practice tests most effectively before exam day
Related practice questions
Related 300-410 practice-question pages
Use these pages to review the topic behind this question. This is how one missed question becomes focused revision.
Layer 3 Technologies practice questions
Practise 300-410 questions linked to Layer 3 Technologies.
EIGRP Troubleshooting practice questions
Practise 300-410 questions linked to EIGRP Troubleshooting.
OSPF Troubleshooting (v2/v3) practice questions
Practise 300-410 questions linked to OSPF Troubleshooting (v2/v3).
BGP Troubleshooting practice questions
Practise 300-410 questions linked to BGP Troubleshooting.
Route Redistribution practice questions
Practise 300-410 questions linked to Route Redistribution.
Policy-Based Routing (PBR) practice questions
Practise 300-410 questions linked to Policy-Based Routing (PBR).
VRF-Lite practice questions
Practise 300-410 questions linked to VRF-Lite.
Route Maps and Route Filtering practice questions
Practise 300-410 questions linked to Route Maps and Route Filtering.
Administrative Distance practice questions
Practise 300-410 questions linked to Administrative Distance.
Route Summarization practice questions
Practise 300-410 questions linked to Route Summarization.
Bidirectional Forwarding Detection (BFD) practice questions
Practise 300-410 questions linked to Bidirectional Forwarding Detection (BFD).
VPN Technologies practice questions
Practise 300-410 questions linked to VPN Technologies.
Practice this exam
Start a free 300-410 practice session
Short sessions build daily habit. Longer sessions build exam-day stamina. Try a timed session to simulate real conditions.
FAQ
Questions learners often ask
What does this 300-410 question test?
IPv6 Traffic Filtering and uRPF — This question tests IPv6 Traffic Filtering and uRPF — Read the scenario before looking for a memorised answer..
What is the correct answer to this question?
The correct answer is: The packet is dropped by uRPF because strict mode requires the source to be reachable via the receiving interface. — The packet is dropped by uRPF (unicast Reverse Path Forwarding) in strict mode because the `ipv6 verify unicast source reachable-via rx` command checks that the source address 2001:db8:3::100 is reachable via the receiving interface (GigabitEthernet0/5). The route for the source prefix 2001:db8:3::48 points out GigabitEthernet0/6, not the receiving interface, so uRPF fails and drops the packet before the ACL is evaluated.
What should I do if I get this 300-410 question wrong?
Identify which exam domain this question belongs to, review the core concept, then practise similar questions from the same domain.
What is the key concept behind this question?
Read the scenario before looking for a memorised answer.
About these practice questions
Courseiva creates original exam-style practice questions with explanations and wrong-answer analysis. It does not publish real exam questions, exam dumps, or protected exam content. Learn why practice questions differ from exam dumps →
Keep practising
More 300-410 practice questions
- Drag and drop the steps to negotiate an IKEv2 IPsec site-to-site tunnel into the correct order, from first to last.
- Drag and drop the steps to troubleshoot an IPsec site-to-site VPN adjacency failure into the correct order, from first t…
- Drag and drop the steps to verify and validate the operational state of an IPsec site-to-site VPN into the correct order…
- Consider the following configuration snippet: ip cef ! interface GigabitEthernet0/0 ip address 10.0.0.1 255.255.255.25…
- A router is configured with 'logging host 10.1.1.100' and 'logging trap informational'. The engineer notices that syslog…
- Drag and drop the steps to configure a GRE tunnel for IPv6 over IPv4 into the correct order, from first to last.
Last reviewed: Jul 4, 2026
This 300-410 practice question is part of Courseiva's free Cisco certification practice question bank. Courseiva provides original exam-style practice questions with explanations, topic-based practice, mock exams, readiness tracking, and study analytics to help learners prepare for the 300-410 exam.
Question Discussion
Share a tip, memory trick, or ask about the reasoning behind this question. Do not post real exam questions, leaked content, braindumps, or copyrighted exam material. Comments are moderated and may be removed without notice.
Sign in to join the discussion.