Drag or tap steps into the slots.
Steps
Order
1Step 1
2Step 2
3Step 3
4Step 4
mediumDrag & Drop
300-410 Practice Question: Drag and drop the steps to configure a GRE tunnel…
Drag and drop the steps to configure a GRE tunnel for IPv6 over IPv4 into the correct order, from first to last.
Answer choices
Why each option matters
Answer the question above first, then reveal the full breakdown to understand why each option is right or wrong.
Correct answer & explanation
✓
Create tunnel interface with 'interface tunnel0'
The correct order follows the standard GRE tunnel configuration workflow for IPv6 over IPv4: first create the tunnel interface with 'interface tunnel0', then assign an IPv6 address to the tunnel, set the tunnel source, set the tunnel destination. Note that option E is incorrect because the correct command for IPv6 over IPv4 is 'tunnel mode gre ip', not 'tunnel mode gre ipv6'. Therefore, the correct steps are A, B, C, D only.
Answer analysis
Option-by-option breakdown
For each option: why learners choose it and why it is or isn't the right answer here.
- ✗
Configure tunnel mode as 'tunnel mode gre ipv6'
Why it's wrong here
The proper command to encapsulate IPv6 over IPv4 is 'tunnel mode gre ip', not 'tunnel mode gre ipv6'.
Go deeper
Related to this question
About these practice questions
One of 1,401 original 300-410 practice questions on Courseiva, each with a full explanation and wrong-answer analysis — not exam dumps or protected exam content. Learn why practice questions differ from exam dumps →
JA
Written by Johnson Ajibi, MSc IT Security
Senior Network & Security Engineer · founder of Courseiva
This 300-410 practice question is part of Courseiva's free Cisco certification practice question bank. Courseiva provides original exam-style practice questions with explanations, topic-based practice, mock exams, readiness tracking, and study analytics to help learners prepare for the 300-410 exam.