Question 1mediummultiple choice
Full question →mediummultiple choiceObjective-mapped
A network technician is configuring a small office network with one router and one managed switch. The network has two VLANs: VLAN 10 (Sales) and VLAN 20 (Engineering). Both VLANs need internet access, and inter-VLAN routing is not required. The technician configures the router's single physical interface with IP 192.168.1.1/24 and creates subinterfaces for VLAN 10 (192.168.10.1/24) and VLAN 20 (192.168.20.1/24). The switch port connecting to the router is configured as an access port in VLAN 10. Which of the following is the MOST likely result?
Answer choices
Why each option matters
Good practice is not just finding the correct option. The wrong answers often show the exact trap the exam wants you to fall into.
A
Best answer
Only VLAN 10 can access the internet; VLAN 20 cannot.
Because the switch port is an access port in VLAN 10, only VLAN 10 traffic is forwarded to the router. VLAN 20 traffic is blocked, so only VLAN 10 can reach the internet.
B
Distractor review
Both VLANs can access the internet.
This would require the switch port to be a trunk port carrying both VLANs. An access port only carries a single VLAN.
C
Distractor review
Only VLAN 20 can access the internet; VLAN 10 cannot.
The access port is configured for VLAN 10, not VLAN 20. Therefore VLAN 20 traffic is blocked on that port.
D
Distractor review
Neither VLAN can access the internet.
VLAN 10 traffic is allowed on the access port, so VLAN 10 devices can reach the router's subinterface and the internet. VLAN 20 cannot, but VLAN 10 can.
Common exam trap
Common exam trap: an active trunk can still block the VLAN you need
A trunk being up does not prove every VLAN is crossing it. Check allowed VLAN lists, native VLAN mismatch, VLAN existence and access-port assignment.
Technical deep dive
How to think about this question
VLAN questions usually combine access-port and trunking clues. The key is to identify whether the issue is local to one switchport, caused by the trunk, or caused by the VLAN not existing where it needs to exist.
KKey Concepts to Remember
- Access ports place end devices into a single VLAN.
- Trunk ports carry multiple VLANs between switches.
- Allowed VLAN lists decide which VLANs can cross a trunk.
- Native VLAN mismatch can create confusing symptoms.
TExam Day Tips
- Use show vlan brief to verify access VLANs.
- Use show interfaces trunk to verify trunk state and allowed VLANs.
- Do not treat every same-VLAN issue as a routing problem.
Related practice questions
Related 220-1101 practice-question pages
Use these pages to review the topic behind this question. This is how one missed question becomes focused revision.
CompTIA A+ hardware practice questions
Practise 220-1101 questions linked to CompTIA A+ hardware.
CompTIA A+ mobile devices practice questions
Practise 220-1101 questions linked to CompTIA A+ mobile devices.
CompTIA A+ networking practice questions
Practise 220-1101 questions linked to CompTIA A+ networking.
CompTIA A+ operating systems practice questions
Practise 220-1101 questions linked to CompTIA A+ operating systems.
CompTIA A+ security practice questions
Practise 220-1101 questions linked to CompTIA A+ security.
CompTIA A+ software troubleshooting questions
Practise 220-1101 questions linked to CompTIA A+ software troubleshooting questions.
CompTIA A+ operational procedures questions
Practise 220-1101 questions linked to CompTIA A+ operational procedures questions.
More questions from this exam
Keep practising from the same exam bank, or move into a focused topic page if this question exposed a weak area.
Question 1
A user reports intermittent network connectivity on a desktop computer. The technician observes that the Ethernet link light on the NIC turns off for a few seconds and then turns back on. The cable passes a wiremap test, the switch port is verified good with another device, and the NIC driver is updated. The issue occurs more frequently when the computer's case fan runs at high speed. Which of the following is the MOST likely cause?
Question 2
A workstation is unable to connect to the internet. The technician runs the 'ipconfig' command and sees the IPv4 address is 169.254.15.200 with a subnet mask of 255.255.0.0. The workstation can ping other devices on the local subnet but cannot ping the default gateway or any external addresses. Which TWO actions should the technician take to resolve this issue? (Select two.)
Question 3
A workstation is connected to a managed switch. It obtains a valid IP address (192.168.10.50) from the DHCP server, but it cannot ping the default gateway (192.168.10.1). The link light on both the workstation NIC and the switch port are solid green. Other workstations on the same switch CAN ping the default gateway successfully. The technician accesses the switch management interface and finds that the workstation's port is configured as an access port on VLAN 10. The default gateway is located on VLAN 20. An inter-VLAN router is configured but not explicitly allowing VLAN 10 access to VLAN 20. Which of the following is the MOST likely cause of the problem?
Question 4
A company develops a web application that relies on a custom library available only for a specific Linux distribution. They want to deploy the application in the cloud with minimal administrative overhead, but they need full control over the software stack, including the ability to install the custom library and configure the web server. Which cloud service model BEST meets these requirements?
Question 5
A company has a legacy virtual machine running on a deprecated hypervisor (Hyper-V). They want to migrate this VM to a new hypervisor (VMware vSphere) hosted in a private cloud while preserving the VM's configuration, installed applications, and data. The migration must be performed with minimal downtime. Which of the following methods is MOST appropriate?
Question 6
A company hosts a critical database on a virtual machine in a public cloud. The database requires persistent storage that must be retained even if the VM is terminated. The storage must also be accessible from multiple VMs simultaneously for a future high-availability configuration. Which type of cloud storage BEST meets these requirements?
FAQ
Questions learners often ask
What does this 220-1101 question test?
Access ports place end devices into a single VLAN.
What is the correct answer to this question?
The correct answer is: Only VLAN 10 can access the internet; VLAN 20 cannot. — The switch port connected to the router is configured as an access port in VLAN 10. This means the switch will only forward frames belonging to VLAN 10 on that port, and it will strip any VLAN tags. The router's subinterfaces expect to receive tagged frames for both VLANs. Since only traffic from VLAN 10 reaches the router, only devices in VLAN 10 can communicate with the router's subinterface and thus access the internet. Devices in VLAN 20 cannot reach the router, so they have no internet access. The correct solution would be to configure that switch port as a trunk port allowing both VLANs.
What should I do if I get this 220-1101 question wrong?
Then try more questions from the same exam bank and focus on understanding why the wrong options are tempting.
Discussion
Loading comments…
Sign in to join the discussion.