- A
The BGP ASN is private and not allowed
Why wrong: Private ASNs are allowed.
- B
The VLAN ID is incorrect
Why wrong: VLAN is configured.
- C
The Direct Connect gateway is not associated with the virtual private gateway or route propagation is not enabled
Routes are not being advertised.
- D
The BGP session is not established
Why wrong: BGP status shows 'up'.
ANS-C01 Network Management and Operations Practice Question
This ANS-C01 practice question tests your understanding of network management and operations. The scenario asks you to isolate a root cause — eliminate options that address a different problem before choosing. After answering, compare your reasoning against the explanation and wrong-answer breakdown below. Once you have made your selection, read the full explanation to reinforce the concept and understand why each distractor is designed to mislead on exam day.
Refer to the exhibit. A Direct Connect private virtual interface is in the 'available' state, and the BGP session is up. However, the on-premises network cannot reach any resources in the VPC attached to the Direct Connect gateway. What is the MOST likely cause?
Clue words in this question
Noticing these words before you look at the options changes how you read each choice.
Clue:
"most likely"Why it matters: Probability qualifier — the question wants the most probable cause or outcome, not a guaranteed one. Eliminate low-probability options.
Answer choices
Why each option matters
Answer the question above first, then reveal the full breakdown to understand why each option is right or wrong.
Correct answer & explanation
The Direct Connect gateway is not associated with the virtual private gateway or route propagation is not enabled
The correct answer is C. Even though the Direct Connect private virtual interface is in the 'available' state and the BGP session is up, the on-premises network cannot reach VPC resources because the Direct Connect gateway is not associated with the virtual private gateway or route propagation is not enabled. This association is necessary for route exchange between the VPC and on-premises network. Option A is incorrect because the BGP ASN being private is allowed; the BGP session is up indicating ASN is valid. Option B is incorrect because the VLAN ID is irrelevant once the virtual interface is available and BGP is up. Option D is incorrect because the BGP session is established.
Key principle: A trunk being up does not mean the VLAN is allowed across it. Always verify the allowed VLAN list and whether the VLAN exists on both switches.
Answer analysis
Option-by-option breakdown
For each option: why learners choose it and why it is or isn't the right answer here.
- ✗
The BGP ASN is private and not allowed
Why it's wrong here
Private ASNs are allowed.
- ✗
The VLAN ID is incorrect
Why it's wrong here
VLAN is configured.
- ✓
The Direct Connect gateway is not associated with the virtual private gateway or route propagation is not enabled
Why this is correct
Routes are not being advertised.
Clue confirmation
The clue word "most likely" in the question point toward this answer.
Related concept
Access ports place end devices into a single VLAN.
- ✗
The BGP session is not established
Why it's wrong here
BGP status shows 'up'.
Common exam traps
Common exam trap: an active trunk can still block the VLAN you need
A trunk being up does not prove every VLAN is crossing it. Check allowed VLAN lists, native VLAN mismatch, VLAN existence and access-port assignment.
Trap categories for this question
Command / output trap
BGP status shows 'up'.
Detailed technical explanation
How to think about this question
VLAN questions usually combine access-port and trunking clues. The key is to identify whether the issue is local to one switchport, caused by the trunk, or caused by the VLAN not existing where it needs to exist.
KKey Concepts to Remember
- Access ports place end devices into a single VLAN.
- Trunk ports carry multiple VLANs between switches.
- Allowed VLAN lists decide which VLANs can cross a trunk.
- Native VLAN mismatch can create confusing symptoms.
TExam Day Tips
- Use show vlan brief to verify access VLANs.
- Use show interfaces trunk to verify trunk state and allowed VLANs.
- Do not treat every same-VLAN issue as a routing problem.
Key takeaway
A trunk being up does not mean the VLAN is allowed across it. Always verify the allowed VLAN list and whether the VLAN exists on both switches.
Real-world example
How this comes up in practice
A company's IT admin needs to give a contractor read-only access to production logs without sharing account credentials. Using role-based access control (RBAC) and temporary scoped permissions — not a permanent shared password — is the correct pattern. Questions like this test whether you can apply least-privilege access across cloud identity services.
Visual reference
What to study next
Got this wrong? Here's your next step.
Review VLAN allowed lists, native VLAN mismatch detection, and how to verify VLAN membership with show vlan brief and show interfaces trunk. Then practise related ANS-C01 questions on switching, trunking, and access-port configuration.
- →
Network Management and Operations — study guide chapter
Learn the concepts, then practise the questions
- →
Network Management and Operations practice questions
Targeted practice on this topic area only
- →
All ANS-C01 questions
1,705 questions across all exam domains
- →
AWS Certified Advanced Networking Specialty ANS-C01 study guide
Full concept coverage aligned to exam objectives
- →
ANS-C01 practice test guide
How to use practice tests most effectively before exam day
Related practice questions
Related ANS-C01 practice-question pages
Use these pages to review the topic behind this question. This is how one missed question becomes focused revision.
Network Management and Operations practice questions
Practise ANS-C01 questions linked to Network Management and Operations.
Network Security, Compliance and Governance practice questions
Practise ANS-C01 questions linked to Network Security, Compliance and Governance.
Network Design practice questions
Practise ANS-C01 questions linked to Network Design.
Network Implementation practice questions
Practise ANS-C01 questions linked to Network Implementation.
ANS-C01 fundamentals practice questions
Practise ANS-C01 questions linked to ANS-C01 fundamentals.
ANS-C01 scenario practice questions
Practise ANS-C01 questions linked to ANS-C01 scenario.
ANS-C01 troubleshooting practice questions
Practise ANS-C01 questions linked to ANS-C01 troubleshooting.
Practice this exam
Start a free ANS-C01 practice session
Short sessions build daily habit. Longer sessions build exam-day stamina. Try a timed session to simulate real conditions.
FAQ
Questions learners often ask
What does this ANS-C01 question test?
Network Management and Operations — This question tests Network Management and Operations — Access ports place end devices into a single VLAN..
What is the correct answer to this question?
The correct answer is: The Direct Connect gateway is not associated with the virtual private gateway or route propagation is not enabled — The correct answer is C. Even though the Direct Connect private virtual interface is in the 'available' state and the BGP session is up, the on-premises network cannot reach VPC resources because the Direct Connect gateway is not associated with the virtual private gateway or route propagation is not enabled. This association is necessary for route exchange between the VPC and on-premises network. Option A is incorrect because the BGP ASN being private is allowed; the BGP session is up indicating ASN is valid. Option B is incorrect because the VLAN ID is irrelevant once the virtual interface is available and BGP is up. Option D is incorrect because the BGP session is established.
What should I do if I get this ANS-C01 question wrong?
Review VLAN allowed lists, native VLAN mismatch detection, and how to verify VLAN membership with show vlan brief and show interfaces trunk. Then practise related ANS-C01 questions on switching, trunking, and access-port configuration.
Are there clue words in this question I should notice?
Yes — watch for: "most likely". Probability qualifier — the question wants the most probable cause or outcome, not a guaranteed one. Eliminate low-probability options.
What is the key concept behind this question?
Access ports place end devices into a single VLAN.
About these practice questions
Courseiva creates original exam-style practice questions with explanations and wrong-answer analysis. It does not publish real exam questions, exam dumps, or protected exam content. Learn why practice questions differ from exam dumps →
Keep practising
More ANS-C01 practice questions
- A financial services company has a VPC with a public subnet and a private subnet. EC2 instances in the private subnet ne…
- A company is designing a network security architecture for a multi-account environment using AWS Transit Gateway. The se…
- A company is using AWS Direct Connect to connect its on-premises network to AWS. The company wants to encrypt all traffi…
- A company uses AWS Transit Gateway to connect multiple VPCs and on-premises networks via AWS Site-to-Site VPN. The secur…
- A company runs a web application on EC2 instances behind an Application Load Balancer (ALB). The application must be acc…
- A global e-commerce company uses a hub-and-spoke network topology with a transit VPC in us-east-1. Each spoke VPC has an…
Last reviewed: Jun 20, 2026
This ANS-C01 practice question is part of Courseiva's free Amazon Web Services certification practice question bank. Courseiva provides original exam-style practice questions with explanations, topic-based practice, mock exams, readiness tracking, and study analytics to help learners prepare for the ANS-C01 exam.
Question Discussion
Share a tip, memory trick, or ask about the reasoning behind this question. Do not post real exam questions, leaked content, braindumps, or copyrighted exam material. Comments are moderated and may be removed without notice.
Sign in to join the discussion.