VCP-DCV vSphere Lifecycle Management Practice Question
During a vLCM remediation, one host fails with error 'Could not complete the operation due to a network error'. What is the first troubleshooting step?
⚠ Common exam trap
VCP-DCV often tests whether candidates jump to remediation actions (reset image, restart service, reboot) instead of performing basic connectivity troubleshooting first when the error message explicitly names a network condition.
Answer choices
Why each option matters
Answer the question above first, then reveal the full breakdown to understand why each option is right or wrong.
Correct answer & explanation
✓
Check network connectivity between vCenter and the host.
The error 'Could not complete the operation due to a network error' during vLCM remediation indicates that vCenter Server lost communication with the ESXi host mid-operation. Since vLCM remediation pushes an image payload from vCenter to the host over the management network, the first logical step is to verify that vCenter can reach the host on the management VMkernel interface (typically port 443 and 902). Confirming connectivity rules out transient network issues before touching the vLCM image or host state.
Answer analysis
Option-by-option breakdown
For each option: why learners choose it and why it is or isn't the right answer here.
- ✗
Reset the vLCM image.
Why it's wrong here
Resetting the vLCM image alters the desired-state configuration rather than investigating the network error, potentially widening the fault. It is tempting because image resets resolve corrupted desired-state definitions, and would be correct when remediation fails due to an invalid or inconsistent image specification.
- ✓
Check network connectivity between vCenter and the host.
Why this is correct
The error explicitly cites a network problem, so verifying connectivity between vCenter and the ESXi host is the logical first step. Remediation depends on that channel, and a dropped or blocked connection would halt the operation before any configuration issue matters.
- ✗
Restart the vLCM service.
Why it's wrong here
Restarting the vLCM service assumes the fault lies in the service itself, yet the error explicitly indicates a network failure, so connectivity must be checked first. It is tempting because service restarts fix stuck vLCM tasks, and would be correct if the service were unresponsive rather than reporting network errors.
- ✗
Reboot the host.
Why it's wrong here
Rebooting the host discards diagnostic state and does not address the reported network error, delaying identification of the actual connectivity fault. It is tempting because reboots clear many transient ESXi issues, and would be reasonable once logs confirm a hung management agent rather than a network problem.
Go deeper
Related to this question
About these practice questions
Courseiva writes every VCP-DCV question from scratch — 281 in total, each with an explanation and a wrong-answer breakdown. None are copied from real exams or dumps. Learn why practice questions differ from exam dumps →
JA
Written and reviewed by Johnson Ajibi, MSc IT Security
Senior Network & Security Engineer · founder of Courseiva
Last reviewed September 2026 · checked against the official VMware exam blueprint
This VCP-DCV practice question is part of Courseiva's free VMware certification practice question bank. Courseiva provides original exam-style practice questions with explanations, topic-based practice, mock exams, readiness tracking, and study analytics to help learners prepare for the VCP-DCV exam.