PCNSA Policy Evaluation and Management Practice Question
This PCNSA practice question tests your understanding of policy evaluation and management. Match the stated requirement to the specific cloud service, access model, or configuration option — many options are valid in isolation but not for this scenario. After answering, compare your reasoning against the explanation and wrong-answer breakdown below. Once you have made your selection, read the full explanation to reinforce the concept and understand why each distractor is designed to mislead on exam day.
A network administrator notices that traffic from a specific subnet is being denied even though there is a permit rule that matches the source and destination. The rulebase has over 500 rules. What is the most likely cause?
Clue words in this question
Noticing these words before you look at the options changes how you read each choice.
Clue: "most likely"
Why it matters: Probability qualifier — the question wants the most probable cause or outcome, not a guaranteed one. Eliminate low-probability options.
Answer the question above first, then reveal the full breakdown to understand why each option is right or wrong.
Correct answer & explanation
✓
A previous rule with a broader match is denying the traffic before reaching the permit rule.
Option B is correct because rule order matters; a previous rule with a broader match and deny action will block traffic before reaching the permit rule. Option A is wrong because the implicit deny is at the end, but rules above can deny. Option C is irrelevant; application override does not cause denial. Option D is about NAT, not denial.
Key principle: Count usable hosts — not total addresses — and remember that the network and broadcast addresses are not available to hosts in standard IPv4 subnets.
Answer analysis
Option-by-option breakdown
For each option: why learners choose it and why it is or isn't the right answer here.
✗
The destination NAT is causing asymmetric routing.
Common exam trap: usable hosts are not the same as total addresses
Subnetting questions often tempt you into counting all addresses. In normal IPv4 subnets, the network and broadcast addresses are not usable host addresses.
Detailed technical explanation
How to think about this question
Subnetting questions test whether you can identify the network, broadcast address, usable range, mask and correct subnet. Slow down enough to calculate the block size correctly.
KKey Concepts to Remember
CIDR notation defines the prefix length.
Block size helps identify subnet boundaries.
Network and broadcast addresses are not usable hosts in normal IPv4 subnets.
The required host count determines the smallest suitable subnet.
TExam Day Tips
→Write the block size before choosing the subnet.
→Check whether the question asks for hosts, subnets or a specific address range.
→Do not confuse /24, /25, /26 and /27 host counts.
Key takeaway
Count usable hosts — not total addresses — and remember that the network and broadcast addresses are not available to hosts in standard IPv4 subnets.
Real-world example
How this comes up in practice
A small business has 20 workstations on the 192.168.1.0/24 network and one public IP from its ISP. The router uses PAT (NAT overload) so all 20 devices share one public address using different source ports. NAT questions test whether you understand the four address terms and which direction each translation applies.
What to study next
Got this wrong? Here's your next step.
Review block sizes, usable host formulas (2^n − 2), and how to find network and broadcast addresses for /24 through /30. Then practise related PCNSA subnetting questions on CIDR, address ranges, and subnet selection.
Policy Evaluation and Management — This question tests Policy Evaluation and Management — CIDR notation defines the prefix length..
What is the correct answer to this question?
The correct answer is: A previous rule with a broader match is denying the traffic before reaching the permit rule. — Option B is correct because rule order matters; a previous rule with a broader match and deny action will block traffic before reaching the permit rule. Option A is wrong because the implicit deny is at the end, but rules above can deny. Option C is irrelevant; application override does not cause denial. Option D is about NAT, not denial.
What should I do if I get this PCNSA question wrong?
Review block sizes, usable host formulas (2^n − 2), and how to find network and broadcast addresses for /24 through /30. Then practise related PCNSA subnetting questions on CIDR, address ranges, and subnet selection.
Are there clue words in this question I should notice?
Yes — watch for: "most likely". Probability qualifier — the question wants the most probable cause or outcome, not a guaranteed one. Eliminate low-probability options.
What is the key concept behind this question?
CIDR notation defines the prefix length.
About these practice questions
Courseiva creates original exam-style practice questions with explanations and wrong-answer analysis. It does not publish real exam questions, exam dumps, or protected exam content. Learn why practice questions differ from exam dumps →
Share a tip, memory trick, or ask about the reasoning behind this question. Do not post real exam questions, leaked content, braindumps, or copyrighted exam material. Comments are moderated and may be removed without notice.
This PCNSA practice question is part of Courseiva's free Palo Alto Networks certification practice question bank. Courseiva provides original exam-style practice questions with explanations, topic-based practice, mock exams, readiness tracking, and study analytics to help learners prepare for the PCNSA exam.
Question Discussion
Share a tip, memory trick, or ask about the reasoning behind this question. Do not post real exam questions, leaked content, braindumps, or copyrighted exam material. Comments are moderated and may be removed without notice.
Sign in to join the discussion.