- A
The remote router has a misconfigured route that sends return traffic out the wrong interface.
Correct because if the remote router does not have a route to the local LAN that points to the tunnel interface, the return traffic will be sent out the physical interface without encryption, and the local router will not see corresponding decrypted packets.
- B
The IPsec SA lifetime is set too low, causing frequent rekeying.
Why wrong: Incorrect because frequent rekeying would cause brief interruptions but not a persistent mismatch in packet counts.
- C
The crypto map on the local router is applied to the wrong interface.
Why wrong: Incorrect because if the crypto map were on the wrong interface, the tunnel would likely not be up.
- D
The access list in the crypto map on the remote router is too permissive, encrypting extra traffic.
Why wrong: Incorrect because that would cause the remote router to encrypt more packets, not fewer.
Quick Answer
The answer is a misconfigured route on the remote router that sends return traffic out the wrong interface. When the IPsec VPN tunnel is up but you see a packet encrypt/decrypt mismatch—where encrypted packets far outnumber decrypted ones on the remote side—it indicates that the remote router is encrypting its outbound traffic but failing to decrypt the inbound traffic because those packets never reach the tunnel. This happens because the remote router’s routing table directs return traffic out a physical interface instead of the virtual tunnel interface, causing the local router to encrypt packets that the remote side never processes. On the Cisco CCNP ENARSI 300-410 exam, this scenario tests your understanding that a tunnel being up does not guarantee traffic is flowing correctly; the common trap is to blame encryption algorithms or security associations. Remember the memory tip: “If the tunnel is up but the counts don’t match, check the route—not the crypto.”
300-410 IPsec Site-to-Site VPN Practice Question
This 300-410 practice question tests your understanding of ipsec site-to-site vpn. The scenario asks you to isolate a root cause — eliminate options that address a different problem before choosing. After answering, compare your reasoning against the explanation and wrong-answer breakdown below. Once you have made your selection, read the full explanation to reinforce the concept and understand why each distractor is designed to mislead on exam day.
A network engineer is troubleshooting an IPsec site-to-site VPN where the tunnel is up, but the engineer notices that the 'show crypto ipsec sa' output shows that the number of packets encrypted is much higher than the number of packets decrypted on the remote side. What is the most likely cause?
Clue words in this question
Noticing these words before you look at the options changes how you read each choice.
Clue:
"most likely"Why it matters: Probability qualifier — the question wants the most probable cause or outcome, not a guaranteed one. Eliminate low-probability options.
Answer choices
Why each option matters
Answer the question above first, then reveal the full breakdown to understand why each option is right or wrong.
Correct answer & explanation
The remote router has a misconfigured route that sends return traffic out the wrong interface.
A significant mismatch between encrypted and decrypted packet counts suggests that some packets are being lost or dropped after encryption. The most common cause is a routing issue where the return traffic from the remote side is not taking the VPN tunnel, so the remote router does not decrypt those packets.
Key principle: ACLs process entries top to bottom and stop at the first match. Entry order and interface direction matter as much as the permit or deny statement.
Answer analysis
Option-by-option breakdown
For each option: why learners choose it and why it is or isn't the right answer here.
- ✓
The remote router has a misconfigured route that sends return traffic out the wrong interface.
Why this is correct
Correct because if the remote router does not have a route to the local LAN that points to the tunnel interface, the return traffic will be sent out the physical interface without encryption, and the local router will not see corresponding decrypted packets.
Clue confirmation
The clue word "most likely" in the question point toward this answer.
Related concept
Standard ACLs match source addresses.
- ✗
The IPsec SA lifetime is set too low, causing frequent rekeying.
Why it's wrong here
Incorrect because frequent rekeying would cause brief interruptions but not a persistent mismatch in packet counts.
- ✗
The crypto map on the local router is applied to the wrong interface.
Why it's wrong here
Incorrect because if the crypto map were on the wrong interface, the tunnel would likely not be up.
- ✗
The access list in the crypto map on the remote router is too permissive, encrypting extra traffic.
Why it's wrong here
Incorrect because that would cause the remote router to encrypt more packets, not fewer.
Common exam traps
Common exam trap: ACLs stop at the first match
ACLs are processed top to bottom. The first matching entry wins, and an implicit deny usually exists at the end.
Detailed technical explanation
How to think about this question
ACL questions test precision: source, destination, protocol, port and direction. A generally correct ACL can still fail if it is applied on the wrong interface or in the wrong direction.
KKey Concepts to Remember
- Standard ACLs match source addresses.
- Extended ACLs can match source, destination, protocol and ports.
- The first matching ACL entry is used.
- There is usually an implicit deny at the end.
TExam Day Tips
- Check inbound versus outbound direction.
- Read the ACL from top to bottom.
- Look for a broader permit or deny above the intended line.
Key takeaway
ACLs process entries top to bottom and stop at the first match. Entry order and interface direction matter as much as the permit or deny statement.
Real-world example
How this comes up in practice
A practitioner preparing for the 300-410 exam encounters this exact type of scenario on the job. The correct answer here is not the most general option — it is the best answer for the specific constraint described. ACLs process entries top to bottom and stop at the first match. Entry order and interface direction matter as much as the permit or deny statement. Real exam questions reward reading the full scenario before eliminating options, because the constraint defines which answer fits.
What to study next
Got this wrong? Here's your next step.
Review ACL processing order, placement rules (standard near destination, extended near source), and inbound vs outbound direction. Study wildcard masks and implicit deny. Then practise related 300-410 ACL questions on filtering logic and placement.
- →
IPsec Site-to-Site VPN — study guide chapter
Learn the concepts, then practise the questions
- →
IPsec Site-to-Site VPN practice questions
Targeted practice on this topic area only
- →
All 300-410 questions
2,152 questions across all exam domains
- →
Cisco CCNP ENARSI 300-410 study guide
Full concept coverage aligned to exam objectives
- →
300-410 practice test guide
How to use practice tests most effectively before exam day
Related practice questions
Related 300-410 practice-question pages
Use these pages to review the topic behind this question. This is how one missed question becomes focused revision.
Layer 3 Technologies practice questions
Practise 300-410 questions linked to Layer 3 Technologies.
EIGRP Troubleshooting practice questions
Practise 300-410 questions linked to EIGRP Troubleshooting.
OSPF Troubleshooting (v2/v3) practice questions
Practise 300-410 questions linked to OSPF Troubleshooting (v2/v3).
BGP Troubleshooting practice questions
Practise 300-410 questions linked to BGP Troubleshooting.
Route Redistribution practice questions
Practise 300-410 questions linked to Route Redistribution.
Policy-Based Routing (PBR) practice questions
Practise 300-410 questions linked to Policy-Based Routing (PBR).
VRF-Lite practice questions
Practise 300-410 questions linked to VRF-Lite.
Route Maps and Route Filtering practice questions
Practise 300-410 questions linked to Route Maps and Route Filtering.
Administrative Distance practice questions
Practise 300-410 questions linked to Administrative Distance.
Route Summarization practice questions
Practise 300-410 questions linked to Route Summarization.
Bidirectional Forwarding Detection (BFD) practice questions
Practise 300-410 questions linked to Bidirectional Forwarding Detection (BFD).
VPN Technologies practice questions
Practise 300-410 questions linked to VPN Technologies.
Practice this exam
Start a free 300-410 practice session
Short sessions build daily habit. Longer sessions build exam-day stamina. Try a timed session to simulate real conditions.
FAQ
Questions learners often ask
What does this 300-410 question test?
IPsec Site-to-Site VPN — This question tests IPsec Site-to-Site VPN — Standard ACLs match source addresses..
What is the correct answer to this question?
The correct answer is: The remote router has a misconfigured route that sends return traffic out the wrong interface. — A significant mismatch between encrypted and decrypted packet counts suggests that some packets are being lost or dropped after encryption. The most common cause is a routing issue where the return traffic from the remote side is not taking the VPN tunnel, so the remote router does not decrypt those packets.
What should I do if I get this 300-410 question wrong?
Review ACL processing order, placement rules (standard near destination, extended near source), and inbound vs outbound direction. Study wildcard masks and implicit deny. Then practise related 300-410 ACL questions on filtering logic and placement.
Are there clue words in this question I should notice?
Yes — watch for: "most likely". Probability qualifier — the question wants the most probable cause or outcome, not a guaranteed one. Eliminate low-probability options.
What is the key concept behind this question?
Standard ACLs match source addresses.
About these practice questions
Courseiva creates original exam-style practice questions with explanations and wrong-answer analysis. It does not publish real exam questions, exam dumps, or protected exam content. Learn why practice questions differ from exam dumps →
Last reviewed: Jun 18, 2026
This 300-410 practice question is part of Courseiva's free Cisco certification practice question bank. Courseiva provides original exam-style practice questions with explanations, topic-based practice, mock exams, readiness tracking, and study analytics to help learners prepare for the 300-410 exam.
Question Discussion
Share a tip, memory trick, or ask about the reasoning behind this question. Do not post real exam questions, leaked content, braindumps, or copyrighted exam material. Comments are moderated and may be removed without notice.
Sign in to join the discussion.