Courseiva
VPN Technologies →mediumMultiple Choice

300-410 Practice Question: A network engineer is configuring a GRE tunnel between two Cisco routers

A network engineer is configuring a GRE tunnel between two Cisco routers. The tunnel interface is up, but the engineer cannot ping the remote tunnel endpoint. The physical interfaces are up, and there is a route to the remote physical address. Which command should be used to verify that the tunnel source and destination are correctly configured?

⚠ Common exam trap

The trap here is assuming that 'show ip interface brief' provides enough detail to verify tunnel endpoints, when it only shows the interface IP address (which may be the tunnel IP, not the source/destination).

Answer choices

Why each option matters

Answer the question above first, then reveal the full breakdown to understand why each option is right or wrong.

Correct answer & explanation

✓

show interfaces tunnel 0

The 'show interfaces tunnel 0' command displays detailed information about the tunnel interface, including the configured source and destination addresses, and the tunnel status. It is the most direct way to verify that the tunnel endpoints are correctly configured. Other commands do not show the tunnel source and destination.

Answer analysis

Option-by-option breakdown

For each option: why learners choose it and why it is or isn't the right answer here.

  • ✗

    show ip route

    Why it's wrong here

    'show ip route' confirms there is a route to the remote tunnel destination, which the scenario already states, and shows whether routes point into the tunnel. It does not display the tunnel's configured source, destination or mode, which is what needs checking. Those details are in 'show interfaces tunnel 0', which should be compared with the other router's settings.

  • ✗

    show ip interface brief

    Why it's wrong here

    'show ip interface brief' provides a summary of all interfaces, including their IP addresses and status. It can show if the tunnel interface is up, but it does not display the tunnel source and destination addresses. It is useful for a quick status check but insufficient for verifying tunnel endpoint configuration.

  • ✓

    show interfaces tunnel 0

    Why this is correct

    'show interfaces tunnel 0' displays the tunnel interface status, including the source and destination addresses, and the tunnel protocol. It verifies that the tunnel source and destination are correctly configured and that the tunnel is up. If the tunnel is up but pings fail, it could be a routing issue over the tunnel.

  • ✗

    show crypto session

    Why it's wrong here

    'show crypto session' reports IPsec sessions, which exist only if the GRE tunnel is protected by IPsec, for example with a tunnel protection profile. For a plain GRE tunnel it shows nothing useful, and even with IPsec it would not show the tunnel's source and destination configuration directly. 'show interfaces tunnel 0' shows those parameters for any GRE tunnel.

About these practice questions

This 300-410 question is part of Courseiva's 1,401-question bank — original exam-style content with full explanations and wrong-answer analysis, never real exam questions or exam dumps. Learn why practice questions differ from exam dumps →

How Courseiva writes practice questions · Editorial policy

You might also like

Similar 300-410 questions

Written and reviewed by Johnson Ajibi, MSc IT Security

Security Systems Architect · founder of Courseiva

Last reviewed September 2026 · checked against the official Cisco exam blueprint

This 300-410 practice question is part of Courseiva's free Cisco certification practice question bank. Courseiva provides original exam-style practice questions with explanations, topic-based practice, mock exams, readiness tracking, and study analytics to help learners prepare for the 300-410 exam.