2,011 questions with instant explanations, domain breakdown, and wrong-answer analysis. Built for the real exam.
This is exactly what you see during practice — question, options, and a full explanation after you answer.
A network engineer is troubleshooting an EIGRP adjacency issue between two directly connected routers, R1 and R2. Both routers are configured with the same autonomous system number, but the adjacency fails to come up. The engineer checks the interfaces and verifies that they are up/up. On R1, the output of 'show ip eigrp neighbors' shows nothing. What is the most likely cause of this problem?
EIGRP requires that directly connected neighbors share a common subnet for their interfaces. If R1 and R2 have IP addresses from different subnets, EIGRP will not form an adjacency because the hello packets sent by one router will be considered invalid by the other due to the sub…Read full explanation
A network engineer is troubleshooting a routing issue in an EIGRP network. Router R1 is not learning a specific route from its neighbor R2, even though R2 has the route in its routing table. The engineer checks the EIGRP topology table on R1 and does not see the route. The output of 'show ip eigrp neighbors' shows that R1 and R2 are adjacent. What should the engineer check next?
If R1 and R2 are EIGRP neighbors but R1 does not have the route in its topology table, a distribute-list applied inbound on R1 or outbound on R2 could be filtering the route. Distribute-lists use access-lists or prefix-lists to permit or deny routes during the update process, pre…Read full explanation
An engineer is troubleshooting an EIGRP convergence issue. After a link failure, the network takes an unusually long time to converge. The engineer notices that the EIGRP hello and hold timers are set to the default values. The network has many routers in a hub-and-spoke topology. What is the most likely cause of the slow convergence?
In a hub-and-spoke EIGRP topology, the hub router maintains a large number of neighbor adjacencies. When a link failure occurs, the hub must process many queries and replies, which can overwhelm its CPU. If the CPU is overloaded, hello packets may be dropped, causing neighbor hol…Read full explanation
Answer at your own pace. Explanation and domain tag shown immediately after each answer.
Countdown timer starts immediately. Results and domain scores shown at the end — just like the real exam.
Full explanations on every question
Not just the right answer — you get exactly why each wrong option is wrong, so you learn the concept, not the answer.
Domain score breakdown
After each session see your score by exam domain so you know exactly where to focus study time.
100% free, forever
No subscription, no trial, no email wall. Start a session in under 10 seconds.
Exam-style questions
Scenario-based, precise wording, realistic distractors — written to match what you actually see on exam day.