Network Assurance questions on this certification test your ability to deploy and manage network assurance concepts in scenario-based situations.
Start practicing
Network Assurance — choose a session length
Free · No account required
Domain overview
Use this page to practise Network Assurance questions for this certification. Focus on how the exam tests network assurance in scenario format — understanding the why behind each answer builds more durable knowledge than memorising options.
Exam objectives
Core Network Assurance concepts and how they apply in real-world cloud scenarios.
How to deploy network assurance correctly and verify the outcome.
Troubleshooting network assurance issues by interpreting error output and system state.
Cloud best practices and Network Assurance design trade-offs tested by this certification.
Selecting the most expensive service when a simpler managed option meets the requirement.
Forgetting that cloud resources must be explicitly secured — defaults are rarely secure.
Choosing a global service fix when the issue is region-specific.
Overlooking cost implications of cross-region data transfer in architecture questions.
Click any question to see the full explanation and answer options, or start a focused practice session above.
A network administrator is troubleshooting high CPU utilization on a Catalyst 9300 switch. The output of 'show processes cpu sorted' shows the 'IP Input' process consuming 45% CPU. Which tool should be used to identify the specific packets causing the issue?
2A network engineer is implementing QoS on a WAN link to prioritize voice traffic. Which queuing mechanism provides the lowest latency for real-time traffic?
3A network administrator is troubleshooting a BGP routing issue where routes from an eBGP neighbor are not being installed in the routing table. The 'show ip bgp' output shows the routes are received but not valid. What is the most likely cause?
4A network engineer is designing a multicast network for IPTV. Which protocol is used by routers to discover which multicast groups are of interest to directly connected hosts?
5Which TWO statements are true about IP SLA? (Choose two.)
6Refer to the exhibit. An engineer notices that interface resets have occurred. What is the most likely cause of the interface resets?
7Refer to the exhibit. Which OSPF route type is the default route?
8A company has a core network running OSPF in a single area (area 0). The network consists of four routers: R1, R2, R3, and R4. R1 is connected to R2 and R3. R2 is also connected to R4. R3 is also connected to R4. All links are GigabitEthernet with OSPF cost based on bandwidth (reference bandwidth 100 Gbps). The network engineer notices that traffic from R1 to a subnet behind R4 is taking a suboptimal path: R1 -> R2 -> R4, instead of R1 -> R3 -> R4 which has lower cost. Upon checking OSPF neighbor states, all adjacencies are full. The engineer verifies that the cost on the R1-R3 link is 10 and the cost on the R3-R4 link is 10, while the R1-R2 link cost is 20 and the R2-R4 link cost is 20. The total cost via R2 is 40, via R3 is 20. However, the routing table on R1 shows the next-hop as R2 for the subnet behind R4. What is the most likely cause?
9A network engineer is troubleshooting intermittent connectivity issues between two switches connected via a trunk link. The engineer notices that the port counters show a high number of CRC errors and runts on one side. Which action should the engineer take first?
10A network administrator is deploying a new QoS policy to prioritize voice traffic across a WAN link. The policy must ensure that voice packets are not dropped even during congestion, and that bandwidth is guaranteed for voice. Which queuing mechanism should be used for the voice class?
11Which TWO STP features are used to improve convergence time after a topology change?
12Refer to the exhibit. An administrator needs to ensure that traffic to 192.168.1.0/24 is forwarded via a different path than traffic to 192.168.2.0/24, even though both routes are learned via OSPF with the same metric. Which action should the administrator take?
13A company has a network with multiple VLANs connected via a Layer 3 switch acting as the gateway for all VLANs. The network uses Rapid PVST+ for spanning tree. Recently, the network team added a new access switch to VLAN 100. After the switch was connected, users in VLAN 100 experienced intermittent connectivity, and the Layer 3 switch logs show 'SPANTREE-2-ROOTGUARD_BLOCK' messages for the port connected to the new switch. The new switch is intended to provide additional access ports for VLAN 100. The network team ensured that the new switch's configuration is correct for VLAN 100 access. What is the most likely cause of the issue, and what action should be taken to resolve it?
14Which TWO statements about Cisco DNA Center's Assurance capabilities are correct?
15Refer to the exhibit. A network engineer is troubleshooting a routing issue. The route for 10.0.0.0/8 is learned via EIGRP with metric 2560512. Which change would most likely cause the metric to increase?
16A network administrator is troubleshooting a performance issue in a large enterprise campus network. The network consists of Cisco Catalyst 9300 switches acting as access switches and Cisco Catalyst 9500 switches as distribution. Users on VLAN 10 report intermittent slow file transfers to a server on VLAN 20. The administrator has verified that there are no errors on the links, CPU utilization is normal, and STP topology is stable. The administrator suspects a possible QoS issue. Upon checking the QoS configuration on the access switch, the administrator finds that the default QoS configuration is in place, which trusts the CoS value at the port level. The connected devices are IP phones and PCs; the IP phones mark voice traffic with CoS 5. The server on VLAN 20 is connected to a distribution switch. Which action should the administrator take to most likely resolve the issue?
17Drag and drop the steps for the DHCP DORA process in the correct order.
18Match each wireless standard to its frequency band and maximum data rate.
Deep-dive questions
The most-searched questions in this domain — detailed explanations, worked examples, full answer breakdowns.
Network Assurance questions on this certification test your ability to deploy and manage network assurance concepts in scenario-based situations.
The Courseiva 350-401 question bank contains 18 questions in the Network Assurance domain, covering the 10% of the exam attributed to this domain in the official Cisco blueprint. Click any question to see the full explanation and answer breakdown.
Start with a 10-question focused session to identify your baseline accuracy in this domain. Read every explanation — even for questions you answer correctly — to understand the reasoning. Once you score consistently above 80%, move to a 20–30 question session to confirm depth before moving to the next domain.
Yes — the session launcher on this page draws questions exclusively from the Network Assurance domain. Choose 10, 20, 30, or 50 questions for a focused session, or click individual questions to review them one by one.
Save your results, see per-domain analytics, and get readiness scores — free, for every certification.
Sign Up FreeFree forever · Every certification included