PL-900 Practice Question: Drag and drop the steps to create a custom…

Drag and drop the steps to create a custom connector in Power Automate in the correct order.

Drag steps to the numbered slots on the right, or tap a step then tap a slot.

Steps

Order

1Step 1

2Step 2

3Step 3

4Step 4

5Step 5

Answer choices

Why each option matters

Answer the question above first, then reveal the full breakdown to understand why each option is right or wrong.

Correct answer & explanation

✓

Start from blank, then Define basic information, then Configure endpoints, then Test, then Create connector

Custom connectors start from blank, define info, configure endpoints, test, then create.

Answer analysis

For each option: why learners choose it and why it is or isn't the right answer here.

✓
Start from blank, then Define basic information, then Configure endpoints, then Test, then Create connector
Why this is correct
This is the correct order because you start with a blank template, provide basic info, set up endpoints, test the connection, and finally create the connector.
✗
Start from blank, then Configure endpoints, then Define basic information, then Test, then Create connector
Why it's wrong here
This is incorrect because you must define basic information (like name and description) before configuring endpoints; otherwise, the endpoints may not be properly associated.
✗
Start from blank, then Define basic information, then Test, then Configure endpoints, then Create connector
Why it's wrong here
This is incorrect because testing requires the endpoints to be already configured; you cannot test without first defining the endpoints.
✗
Define basic information, then Start from blank, then Configure endpoints, then Test, then Create connector
Why it's wrong here
This is incorrect because you must first start from a blank connector template before defining any information; otherwise, there is no connector to define.

Go deeper