SSCP Risk Identification, Monitoring and Analysis Practice Question
This SSCP practice question tests your understanding of risk identification, monitoring and analysis. This is a configuration task: choose the command set that satisfies every stated requirement. Small differences — like 'secret' vs 'password' or 'transport input ssh' vs 'all' — change whether the answer is correct. After answering, compare your reasoning against the explanation and wrong-answer breakdown below. Once you have made your selection, read the full explanation to reinforce the concept and understand why each distractor is designed to mislead on exam day.
Drag and drop the steps to configure a static route on a Cisco IOS router into the correct order.
Correct answer & explanation
Static routes require global config mode and must specify the destination network, subnet mask, and next-hop address or exit interface.
Key principle: Count usable hosts — not total addresses — and remember that the network and broadcast addresses are not available to hosts in standard IPv4 subnets.
Common exam traps
Common exam trap: usable hosts are not the same as total addresses
Subnetting questions often tempt you into counting all addresses. In normal IPv4 subnets, the network and broadcast addresses are not usable host addresses.
Detailed technical explanation
How to think about this question
Subnetting questions test whether you can identify the network, broadcast address, usable range, mask and correct subnet. Slow down enough to calculate the block size correctly.
KKey Concepts to Remember
- CIDR notation defines the prefix length.
- Block size helps identify subnet boundaries.
- Network and broadcast addresses are not usable hosts in normal IPv4 subnets.
- The required host count determines the smallest suitable subnet.
TExam Day Tips
- Write the block size before choosing the subnet.
- Check whether the question asks for hosts, subnets or a specific address range.
- Do not confuse /24, /25, /26 and /27 host counts.
Key takeaway
Count usable hosts — not total addresses — and remember that the network and broadcast addresses are not available to hosts in standard IPv4 subnets.
Real-world example
How this comes up in practice
A security analyst at a medium-sized enterprise encounters this scenario during an investigation or architecture review. The correct answer reflects best practice for the specific threat or control described. Count usable hosts — not total addresses — and remember that the network and broadcast addresses are not available to hosts in standard IPv4 subnets. Security exam questions test whether you can match controls to threats in context — not just recall definitions.
What to study next
Got this wrong? Here's your next step.
Review block sizes, usable host formulas (2^n − 2), and how to find network and broadcast addresses for /24 through /30. Then practise related SSCP subnetting questions on CIDR, address ranges, and subnet selection.
- →
Risk Identification, Monitoring and Analysis — study guide chapter
Learn the concepts, then practise the questions
- →
Risk Identification, Monitoring and Analysis practice questions
Targeted practice on this topic area only
- →
All SSCP questions
504 questions across all exam domains
- →
Systems Security Certified Practitioner SSCP study guide
Full concept coverage aligned to exam objectives
- →
SSCP practice test guide
How to use practice tests most effectively before exam day
Related practice questions
Related SSCP practice-question pages
Use these pages to review the topic behind this question. This is how one missed question becomes focused revision.
Risk Identification, Monitoring and Analysis practice questions
Practise SSCP questions linked to Risk Identification, Monitoring and Analysis.
Network and Communications Security practice questions
Practise SSCP questions linked to Network and Communications Security.
Systems and Application Security practice questions
Practise SSCP questions linked to Systems and Application Security.
Security Operations and Administration practice questions
Practise SSCP questions linked to Security Operations and Administration.
Incident Response and Recovery practice questions
Practise SSCP questions linked to Incident Response and Recovery.
Access Controls practice questions
Practise SSCP questions linked to Access Controls.
Cryptography practice questions
Practise SSCP questions linked to Cryptography.
SSCP fundamentals practice questions
Practise SSCP questions linked to SSCP fundamentals.
SSCP scenario practice questions
Practise SSCP questions linked to SSCP scenario.
SSCP troubleshooting practice questions
Practise SSCP questions linked to SSCP troubleshooting.
Practice this exam
Start a free SSCP practice session
Short sessions build daily habit. Longer sessions build exam-day stamina. Try a timed session to simulate real conditions.
FAQ
Questions learners often ask
What does this SSCP question test?
Risk Identification, Monitoring and Analysis — This question tests Risk Identification, Monitoring and Analysis — CIDR notation defines the prefix length..
What exam trap should I watch out for?
Common exam trap: usable hosts are not the same as total addresses: Subnetting questions often tempt you into counting all addresses. In normal IPv4 subnets, the network and broadcast addresses are not usable host addresses.
What should I do if I get this SSCP question wrong?
Review block sizes, usable host formulas (2^n − 2), and how to find network and broadcast addresses for /24 through /30. Then practise related SSCP subnetting questions on CIDR, address ranges, and subnet selection.
What is the key concept behind this question?
CIDR notation defines the prefix length.
About these practice questions
Courseiva creates original exam-style practice questions with explanations and wrong-answer analysis. It does not publish real exam questions, exam dumps, or protected exam content. Learn why practice questions differ from exam dumps →
Last reviewed: Jun 11, 2026
This SSCP practice question is part of Courseiva's free ISC2 certification practice question bank. Courseiva provides original exam-style practice questions with explanations, topic-based practice, mock exams, readiness tracking, and study analytics to help learners prepare for the SSCP exam.
Question Discussion
Share a tip, memory trick, or ask about the reasoning behind this question. Do not post real exam questions, leaked content, braindumps, or copyrighted exam material. Comments are moderated and may be removed without notice.
Sign in to join the discussion.