Operations And Monitoring

Where do you check the status of active control connections in vManage?

Which menu path is used to view the real-time tunnel statistics for a specific vEdge router?

Where do you go in vManage to generate a report on historical bandwidth utilization for a specific site?

Which dashboard component in vManage provides an 'at-a-glance' health score for the entire SD-WAN fabric?

When DCI is implemented via an L3VPN overlay, which OMP attribute is most critical to ensure traffic prefers the direct link over the DCI link for reaching local subnets?

In a multi-homed DCI scenario, you are seeing asymmetric routing. What is the most likely cause within the OMP domain?

You have a DCI configuration where two data centers are connected via a dedicated link. You want to ensure the DCI link is only used if the primary WAN transport fails. How do you achieve this?

Which TWO features are included in the vManage 'Monitor' menu?

When configuring Data Center Interconnect (DCI) between two sites, you notice that routing loops are occurring. What is the most effective way to prevent this in a dual-homed DCI scenario?

Which dashboard provides the most detailed information regarding the health of individual tunnels within an SD-WAN fabric?

If a device is stuck in 'In-Progress' during a template push, what is the first troubleshooting step?

Which THREE parameters are part of the HA state synchronization process?

Which THREE OMP attributes can be used to influence path selection for DCI?

Which TWO indicators would lead you to believe that a site's WAN transport is oversubscribed?

Which TWO dashboards are most useful for a daily operational health check?

When DCI links are used to extend Layer 2, what must you ensure is configured to prevent broadcast storms?

Which THREE actions occur when a device transitions to 'Active' status in an HA pair?

You have configured two different DCI paths. You want to load balance traffic across both paths. What OMP configuration must be set?

When performing a 'Soft Shutdown' on an HA device, what is the expected behavior?