- A
An AP can discover a WLC using DHCP option 43, which provides the WLC management IP address.
Correct because DHCP option 43 is a standard method for APs to learn the WLC IP address during boot.
- B
An AP can discover a WLC by sending a DNS query for 'CISCO-CAPWAP-CONTROLLER.localdomain'.
Correct because APs use DNS resolution for the hostname 'CISCO-CAPWAP-CONTROLLER' to find a WLC.
- C
An AP must have a valid certificate installed to establish a DTLS session with the WLC.
Correct because DTLS encryption between AP and WLC requires certificate-based authentication for secure control and data planes.
- D
An AP can discover a WLC by sending an SNMP broadcast to the local subnet.
Why wrong: Incorrect because APs use CAPWAP discovery messages (broadcast or unicast), not SNMP, to find WLCs.
- E
An AP can be manually configured with the primary WLC name via the AP CLI before joining.
Why wrong: Incorrect because APs do not have a CLI for such configuration; the primary WLC is typically set from the WLC side or via a pre-shared key in the AP image.
Quick Answer
The correct answer is that an AP must have a valid certificate installed to establish a DTLS session with the WLC, because CAPWAP control traffic is encrypted using Datagram Transport Layer Security, and the AP authenticates itself to the controller via X.509 certificates during the join process. This is a foundational concept in the Cisco AP join process and discovery, where the AP first discovers the WLC using methods like DHCP option 43, DNS resolution, or a local subnet broadcast, then initiates a CAPWAP discovery and join sequence. On the ENCOR 350-401 exam, this topic tests your understanding of the full AP lifecycle, and a common trap is confusing the discovery phase (which does not require a certificate) with the secure DTLS tunnel establishment that follows. Remember that discovery is about finding the WLC, but joining requires trust—so think “discover first, then DTLS for security.” A helpful mnemonic is “D-D-C”: Discovery via DHCP/DNS, then DTLS via Certificate.
350-401 Wireless Infrastructure Practice Question
This 350-401 practice question tests your understanding of wireless infrastructure. This is a configuration task: choose the command set that satisfies every stated requirement. Small differences — like 'secret' vs 'password' or 'transport input ssh' vs 'all' — change whether the answer is correct. After answering, compare your reasoning against the explanation and wrong-answer breakdown below. Once you have made your selection, read the full explanation to reinforce the concept and understand why each distractor is designed to mislead on exam day.
Which three statements about Cisco AP join process and discovery are true? (Choose three.)
Answer choices
Why each option matters
Answer the question above first, then reveal the full breakdown to understand why each option is right or wrong.
Correct answer & explanation
An AP can discover a WLC using DHCP option 43, which provides the WLC management IP address.
APs discover WLCs via DHCP option 43, DNS, or local subnet broadcast. They use CAPWAP for control and data. The AP must have a valid certificate for DTLS. APs can be pre-configured with a primary WLC name. APs do not use SNMP to find WLCs.
Key principle: Count usable hosts — not total addresses — and remember that the network and broadcast addresses are not available to hosts in standard IPv4 subnets.
Answer analysis
Option-by-option breakdown
For each option: why learners choose it and why it is or isn't the right answer here.
- ✓
An AP can discover a WLC using DHCP option 43, which provides the WLC management IP address.
- ✓
An AP can discover a WLC by sending a DNS query for 'CISCO-CAPWAP-CONTROLLER.localdomain'.
- ✓
An AP must have a valid certificate installed to establish a DTLS session with the WLC.
Why this is correct
Correct because DTLS encryption between AP and WLC requires certificate-based authentication for secure control and data planes.
Related concept
CIDR notation defines the prefix length.
- ✗
An AP can discover a WLC by sending an SNMP broadcast to the local subnet.
Why it's wrong here
Incorrect because APs use CAPWAP discovery messages (broadcast or unicast), not SNMP, to find WLCs.
- ✗
An AP can be manually configured with the primary WLC name via the AP CLI before joining.
Why it's wrong here
Incorrect because APs do not have a CLI for such configuration; the primary WLC is typically set from the WLC side or via a pre-shared key in the AP image.
Common exam traps
Common exam trap: usable hosts are not the same as total addresses
Subnetting questions often tempt you into counting all addresses. In normal IPv4 subnets, the network and broadcast addresses are not usable host addresses.
Detailed technical explanation
How to think about this question
Subnetting questions test whether you can identify the network, broadcast address, usable range, mask and correct subnet. Slow down enough to calculate the block size correctly.
KKey Concepts to Remember
- CIDR notation defines the prefix length.
- Block size helps identify subnet boundaries.
- Network and broadcast addresses are not usable hosts in normal IPv4 subnets.
- The required host count determines the smallest suitable subnet.
TExam Day Tips
- Write the block size before choosing the subnet.
- Check whether the question asks for hosts, subnets or a specific address range.
- Do not confuse /24, /25, /26 and /27 host counts.
Key takeaway
Count usable hosts — not total addresses — and remember that the network and broadcast addresses are not available to hosts in standard IPv4 subnets.
Real-world example
How this comes up in practice
A network engineer segments a warehouse floor into three subnets: 20 scanners, 5 printers, and 2 management hosts. Picking the wrong mask wastes addresses or leaves too few usable hosts. Exam questions test whether you can apply CIDR notation, calculate block size, and identify the correct usable-host range for a given prefix.
What to study next
Got this wrong? Here's your next step.
Review block sizes, usable host formulas (2^n − 2), and how to find network and broadcast addresses for /24 through /30. Then practise related 350-401 subnetting questions on CIDR, address ranges, and subnet selection.
- →
Wireless Infrastructure — study guide chapter
Learn the concepts, then practise the questions
- →
Wireless Infrastructure practice questions
Targeted practice on this topic area only
- →
All 350-401 questions
2,015 questions across all exam domains
- →
ENCOR 350-401 study guide
Full concept coverage aligned to exam objectives
- →
350-401 practice test guide
How to use practice tests most effectively before exam day
Related practice questions
Related 350-401 practice-question pages
Use these pages to review the topic behind this question. This is how one missed question becomes focused revision.
Architecture practice questions
Practise 350-401 questions linked to Architecture.
Enterprise Network Design practice questions
Practise 350-401 questions linked to Enterprise Network Design.
SD-Access Architecture practice questions
Practise 350-401 questions linked to SD-Access Architecture.
SD-WAN Architecture practice questions
Practise 350-401 questions linked to SD-WAN Architecture.
QoS Architecture practice questions
Practise 350-401 questions linked to QoS Architecture.
Virtualization practice questions
Practise 350-401 questions linked to Virtualization.
Network Function Virtualization practice questions
Practise 350-401 questions linked to Network Function Virtualization.
Virtual Machines and Hypervisors practice questions
Practise 350-401 questions linked to Virtual Machines and Hypervisors.
VRF and Path Isolation practice questions
Practise 350-401 questions linked to VRF and Path Isolation.
Infrastructure practice questions
Practise 350-401 questions linked to Infrastructure.
OSPF practice questions
Practise 350-401 questions linked to OSPF.
BGP practice questions
Practise 350-401 questions linked to BGP.
Practice this exam
Start a free 350-401 practice session
Short sessions build daily habit. Longer sessions build exam-day stamina. Try a timed session to simulate real conditions.
FAQ
Questions learners often ask
What does this 350-401 question test?
Wireless Infrastructure — This question tests Wireless Infrastructure — CIDR notation defines the prefix length..
What is the correct answer to this question?
The correct answer is: An AP can discover a WLC using DHCP option 43, which provides the WLC management IP address. — APs discover WLCs via DHCP option 43, DNS, or local subnet broadcast. They use CAPWAP for control and data. The AP must have a valid certificate for DTLS. APs can be pre-configured with a primary WLC name. APs do not use SNMP to find WLCs.
What should I do if I get this 350-401 question wrong?
Review block sizes, usable host formulas (2^n − 2), and how to find network and broadcast addresses for /24 through /30. Then practise related 350-401 subnetting questions on CIDR, address ranges, and subnet selection.
What is the key concept behind this question?
CIDR notation defines the prefix length.
About these practice questions
Courseiva creates original exam-style practice questions with explanations and wrong-answer analysis. It does not publish real exam questions, exam dumps, or protected exam content. Learn why practice questions differ from exam dumps →
Last reviewed: Jun 18, 2026
This 350-401 practice question is part of Courseiva's free Cisco certification practice question bank. Courseiva provides original exam-style practice questions with explanations, topic-based practice, mock exams, readiness tracking, and study analytics to help learners prepare for the 350-401 exam.
Question Discussion
Share a tip, memory trick, or ask about the reasoning behind this question. Do not post real exam questions, leaked content, braindumps, or copyrighted exam material. Comments are moderated and may be removed without notice.
Sign in to join the discussion.