- A
The route-map will redistribute all routes that match prefix-list EIGRP_ROUTES with metric 100 and type-1.
Why wrong: While sequence 10 permits matching routes, sequence 20 denies all routes if DENY_ALL matches everything, so redistribution may fail.
- B
The route-map has a deny sequence that may block all routes if prefix-list DENY_ALL is configured to permit all.
If DENY_ALL is a catch-all prefix-list (e.g., permit 0.0.0.0/0 le 32), then sequence 20 will deny all routes, overriding sequence 10.
- C
The route-map will only redistribute routes with tag 200.
Why wrong: The tag is set, not matched; redistribution is based on match clauses, not set clauses.
- D
The route-map is not applied to any redistribution command, so it has no effect.
Why wrong: The output shows the route-map is defined, but we don't know if it is applied; however, the question is about the route-map itself.
Quick Answer
The answer is that the route-map’s deny sequence 20, combined with a prefix-list DENY_ALL configured to permit all (e.g., permit 0.0.0.0/0 le 32), will block all routes after sequence 10, effectively stopping redistribution. This occurs because route-map sequences are processed in order; once a route matches a deny clause, it is immediately rejected and not passed to subsequent sequences. On the Cisco CCNP ENARSI 300-410 exam, this scenario tests your ability to troubleshoot route-map blocking redistribution by recognizing that a seemingly harmless deny entry can override earlier permit statements if the matching prefix-list is too broad. A common trap is assuming only permit sequences matter, when in fact a deny with a catch-all prefix-list silently kills redistribution. Remember the memory tip: “Deny last, check the list first”—always verify the prefix-list content behind a deny sequence to ensure it isn’t inadvertently matching everything.
300-410 Route Redistribution Practice Question
This 300-410 practice question tests your understanding of route redistribution. Examine the command output carefully: the correct answer depends on what the output actually shows, not on general recall alone. After answering, compare your reasoning against the explanation and wrong-answer breakdown below. Once you have made your selection, read the full explanation to reinforce the concept and understand why each distractor is designed to mislead on exam day.
A network engineer runs the following command on Router R1:
R1# show route-map REDISTRIBUTE
route-map REDISTRIBUTE, permit, sequence 10 Match clauses:
ip address prefix-list EIGRP_ROUTES
Set clauses: metric 100 metric-type type-1 tag 200 Policy routing matches: 0 packets, 0 bytes
route-map REDISTRIBUTE, deny, sequence 20 Match clauses:
ip address prefix-list DENY_ALL
Set clauses: Policy routing matches: 0 packets, 0 bytes
Based on this output, what is the problem?
Answer choices
Why each option matters
Answer the question above first, then reveal the full breakdown to understand why each option is right or wrong.
Correct answer & explanation
The route-map has a deny sequence that may block all routes if prefix-list DENY_ALL is configured to permit all.
The route-map has a deny sequence 20 that matches prefix-list DENY_ALL. If DENY_ALL is configured to permit all (e.g., permit 0.0.0.0/0 le 32), then all routes will be denied after sequence 10, effectively blocking redistribution. The problem is that the deny sequence may unintentionally block routes that should be redistributed.
Key principle: ACLs process entries top to bottom and stop at the first match. Entry order and interface direction matter as much as the permit or deny statement.
Answer analysis
Option-by-option breakdown
For each option: why learners choose it and why it is or isn't the right answer here.
- ✗
The route-map will redistribute all routes that match prefix-list EIGRP_ROUTES with metric 100 and type-1.
Why it's wrong here
While sequence 10 permits matching routes, sequence 20 denies all routes if DENY_ALL matches everything, so redistribution may fail.
- ✓
The route-map has a deny sequence that may block all routes if prefix-list DENY_ALL is configured to permit all.
Why this is correct
If DENY_ALL is a catch-all prefix-list (e.g., permit 0.0.0.0/0 le 32), then sequence 20 will deny all routes, overriding sequence 10.
Related concept
Standard ACLs match source addresses.
- ✗
The route-map will only redistribute routes with tag 200.
Why it's wrong here
The tag is set, not matched; redistribution is based on match clauses, not set clauses.
- ✗
The route-map is not applied to any redistribution command, so it has no effect.
Why it's wrong here
The output shows the route-map is defined, but we don't know if it is applied; however, the question is about the route-map itself.
Common exam traps
Common exam trap: ACLs stop at the first match
ACLs are processed top to bottom. The first matching entry wins, and an implicit deny usually exists at the end.
Trap categories for this question
Command / output trap
The output shows the route-map is defined, but we don't know if it is applied; however, the question is about the route-map itself.
Detailed technical explanation
How to think about this question
ACL questions test precision: source, destination, protocol, port and direction. A generally correct ACL can still fail if it is applied on the wrong interface or in the wrong direction.
KKey Concepts to Remember
- Standard ACLs match source addresses.
- Extended ACLs can match source, destination, protocol and ports.
- The first matching ACL entry is used.
- There is usually an implicit deny at the end.
TExam Day Tips
- Check inbound versus outbound direction.
- Read the ACL from top to bottom.
- Look for a broader permit or deny above the intended line.
Key takeaway
ACLs process entries top to bottom and stop at the first match. Entry order and interface direction matter as much as the permit or deny statement.
Real-world example
How this comes up in practice
A security administrator must allow nursing staff to reach a patient records server while blocking access from the guest Wi-Fi VLAN. After applying an extended ACL, traffic is still blocked from nursing workstations. The ACL was applied outbound instead of inbound on the wrong interface. Questions like this test ACL direction and placement rules.
What to study next
Got this wrong? Here's your next step.
Review ACL processing order, placement rules (standard near destination, extended near source), and inbound vs outbound direction. Study wildcard masks and implicit deny. Then practise related 300-410 ACL questions on filtering logic and placement.
- →
Route Redistribution — study guide chapter
Learn the concepts, then practise the questions
- →
Route Redistribution practice questions
Targeted practice on this topic area only
- →
All 300-410 questions
2,152 questions across all exam domains
- →
Cisco CCNP ENARSI 300-410 study guide
Full concept coverage aligned to exam objectives
- →
300-410 practice test guide
How to use practice tests most effectively before exam day
Related practice questions
Related 300-410 practice-question pages
Use these pages to review the topic behind this question. This is how one missed question becomes focused revision.
Layer 3 Technologies practice questions
Practise 300-410 questions linked to Layer 3 Technologies.
EIGRP Troubleshooting practice questions
Practise 300-410 questions linked to EIGRP Troubleshooting.
OSPF Troubleshooting (v2/v3) practice questions
Practise 300-410 questions linked to OSPF Troubleshooting (v2/v3).
BGP Troubleshooting practice questions
Practise 300-410 questions linked to BGP Troubleshooting.
Route Redistribution practice questions
Practise 300-410 questions linked to Route Redistribution.
Policy-Based Routing (PBR) practice questions
Practise 300-410 questions linked to Policy-Based Routing (PBR).
VRF-Lite practice questions
Practise 300-410 questions linked to VRF-Lite.
Route Maps and Route Filtering practice questions
Practise 300-410 questions linked to Route Maps and Route Filtering.
Administrative Distance practice questions
Practise 300-410 questions linked to Administrative Distance.
Route Summarization practice questions
Practise 300-410 questions linked to Route Summarization.
Bidirectional Forwarding Detection (BFD) practice questions
Practise 300-410 questions linked to Bidirectional Forwarding Detection (BFD).
VPN Technologies practice questions
Practise 300-410 questions linked to VPN Technologies.
Practice this exam
Start a free 300-410 practice session
Short sessions build daily habit. Longer sessions build exam-day stamina. Try a timed session to simulate real conditions.
FAQ
Questions learners often ask
What does this 300-410 question test?
Route Redistribution — This question tests Route Redistribution — Standard ACLs match source addresses..
What is the correct answer to this question?
The correct answer is: The route-map has a deny sequence that may block all routes if prefix-list DENY_ALL is configured to permit all. — The route-map has a deny sequence 20 that matches prefix-list DENY_ALL. If DENY_ALL is configured to permit all (e.g., permit 0.0.0.0/0 le 32), then all routes will be denied after sequence 10, effectively blocking redistribution. The problem is that the deny sequence may unintentionally block routes that should be redistributed.
What should I do if I get this 300-410 question wrong?
Review ACL processing order, placement rules (standard near destination, extended near source), and inbound vs outbound direction. Study wildcard masks and implicit deny. Then practise related 300-410 ACL questions on filtering logic and placement.
What is the key concept behind this question?
Standard ACLs match source addresses.
About these practice questions
Courseiva creates original exam-style practice questions with explanations and wrong-answer analysis. It does not publish real exam questions, exam dumps, or protected exam content. Learn why practice questions differ from exam dumps →
Last reviewed: Jun 18, 2026
This 300-410 practice question is part of Courseiva's free Cisco certification practice question bank. Courseiva provides original exam-style practice questions with explanations, topic-based practice, mock exams, readiness tracking, and study analytics to help learners prepare for the 300-410 exam.
Question Discussion
Share a tip, memory trick, or ask about the reasoning behind this question. Do not post real exam questions, leaked content, braindumps, or copyrighted exam material. Comments are moderated and may be removed without notice.
Sign in to join the discussion.