Courseiva
← 350-501
Full test
Question 329 of 500
Networking →mediumDrag & DropObjective-mapped

350-501 Networking Practice Question

This 350-501 practice question tests your understanding of networking. This is a configuration task: choose the command set that satisfies every stated requirement. Small differences — like 'secret' vs 'password' or 'transport input ssh' vs 'all' — change whether the answer is correct. After answering, compare your reasoning against the explanation and wrong-answer breakdown below. Once you have made your selection, read the full explanation to reinforce the concept and understand why each distractor is designed to mislead on exam day.

Drag and drop the steps to configure a VLAN on a Cisco switch into the correct order.

Correct answer & explanation

VLAN configuration involves creating the VLAN, optionally naming it, and then assigning ports to it.

Key principle: A trunk being up does not mean the VLAN is allowed across it. Always verify the allowed VLAN list and whether the VLAN exists on both switches.

Common exam traps

Common exam trap: an active trunk can still block the VLAN you need

A trunk being up does not prove every VLAN is crossing it. Check allowed VLAN lists, native VLAN mismatch, VLAN existence and access-port assignment.

Detailed technical explanation

How to think about this question

VLAN questions usually combine access-port and trunking clues. The key is to identify whether the issue is local to one switchport, caused by the trunk, or caused by the VLAN not existing where it needs to exist.

KKey Concepts to Remember

  • Access ports place end devices into a single VLAN.
  • Trunk ports carry multiple VLANs between switches.
  • Allowed VLAN lists decide which VLANs can cross a trunk.
  • Native VLAN mismatch can create confusing symptoms.

TExam Day Tips

  • Use show vlan brief to verify access VLANs.
  • Use show interfaces trunk to verify trunk state and allowed VLANs.
  • Do not treat every same-VLAN issue as a routing problem.

Key takeaway

A trunk being up does not mean the VLAN is allowed across it. Always verify the allowed VLAN list and whether the VLAN exists on both switches.

Real-world example

How this comes up in practice

A help-desk technician troubleshoots why a newly connected PC cannot reach shared printers on the same floor. The cable is good, the switch port is active, but the PC is in VLAN 20 and the printers are in VLAN 10. The uplink trunk only allows VLAN 10. A trunk being up does not mean every VLAN crosses it.

What to study next

Got this wrong? Here's your next step.

Review VLAN allowed lists, native VLAN mismatch detection, and how to verify VLAN membership with show vlan brief and show interfaces trunk. Then practise related 350-501 questions on switching, trunking, and access-port configuration.

Related practice questions

Related 350-501 practice-question pages

Use these pages to review the topic behind this question. This is how one missed question becomes focused revision.

Architecture practice questions

Practise 350-501 questions linked to Architecture.

Networking practice questions

Practise 350-501 questions linked to Networking.

MPLS and Segment Routing practice questions

Practise 350-501 questions linked to MPLS and Segment Routing.

Automation and Quality of Service practice questions

Practise 350-501 questions linked to Automation and Quality of Service.

Services practice questions

Practise 350-501 questions linked to Services.

Automation and Assurance practice questions

Practise 350-501 questions linked to Automation and Assurance.

350-501 fundamentals practice questions

Practise 350-501 questions linked to 350-501 fundamentals.

350-501 scenario practice questions

Practise 350-501 questions linked to 350-501 scenario.

350-501 troubleshooting practice questions

Practise 350-501 questions linked to 350-501 troubleshooting.

Practice this exam

Start a free 350-501 practice session

Short sessions build daily habit. Longer sessions build exam-day stamina. Try a timed session to simulate real conditions.

10 questions20 questions30 questions50 questionsTimed 30
350-501 practice-test guide →Study guide →Browse all practice tests

FAQ

Questions learners often ask

What does this 350-501 question test?

Networking — This question tests Networking — Access ports place end devices into a single VLAN..

What exam trap should I watch out for?

Common exam trap: an active trunk can still block the VLAN you need: A trunk being up does not prove every VLAN is crossing it. Check allowed VLAN lists, native VLAN mismatch, VLAN existence and access-port assignment.

What should I do if I get this 350-501 question wrong?

Review VLAN allowed lists, native VLAN mismatch detection, and how to verify VLAN membership with show vlan brief and show interfaces trunk. Then practise related 350-501 questions on switching, trunking, and access-port configuration.

What is the key concept behind this question?

Access ports place end devices into a single VLAN.

About these practice questions

Courseiva creates original exam-style practice questions with explanations and wrong-answer analysis. It does not publish real exam questions, exam dumps, or protected exam content. Learn why practice questions differ from exam dumps →

How Courseiva writes practice questions · Editorial policy

Last reviewed: Jun 11, 2026

Question Discussion

Share a tip, memory trick, or ask about the reasoning behind this question. Do not post real exam questions, leaked content, braindumps, or copyrighted exam material. Comments are moderated and may be removed without notice.

Loading comments…

Sign in to join the discussion.

This 350-501 practice question is part of Courseiva's free Cisco certification practice question bank. Courseiva provides original exam-style practice questions with explanations, topic-based practice, mock exams, readiness tracking, and study analytics to help learners prepare for the 350-501 exam.