- → Why each wrong option is wrong in this specific scenario
- → When each wrong option would be correct
- → Real-world analogy and exam trap analysis
- → Related glossary terms and similar practice questions
CCNA Practice Question: Drag and drop the following steps into the…
This 200-301 practice question tests your understanding of 200-301 exam topics. Examine the command output carefully: the correct answer depends on what the output actually shows, not on general recall alone. After answering, compare your reasoning against the explanation and wrong-answer breakdown below. Once you have made your selection, read the full explanation to reinforce the concept and understand why each distractor is designed to mislead on exam day.
Drag and drop the following steps into the correct order to configure a Cisco IOS-XE router as a DHCP server and enable a relay agent on a different interface.
Correct answer & explanation
First, the DHCP server configuration must be completed with an excluded address range and a pool. Then, the relay agent is configured on the interface that receives client broadcasts. Finally, the DORA process occurs in the correct order: Discover, Offer, Request, Acknowledge.
Key principle: Count usable hosts — not total addresses — and remember that the network and broadcast addresses are not available to hosts in standard IPv4 subnets.
Common exam traps
Common exam trap: usable hosts are not the same as total addresses
Subnetting questions often tempt you into counting all addresses. In normal IPv4 subnets, the network and broadcast addresses are not usable host addresses.
Detailed technical explanation
How to think about this question
Subnetting questions test whether you can identify the network, broadcast address, usable range, mask and correct subnet. Slow down enough to calculate the block size correctly.
KKey Concepts to Remember
- CIDR notation defines the prefix length.
- Block size helps identify subnet boundaries.
- Network and broadcast addresses are not usable hosts in normal IPv4 subnets.
- The required host count determines the smallest suitable subnet.
TExam Day Tips
- Write the block size before choosing the subnet.
- Check whether the question asks for hosts, subnets or a specific address range.
- Do not confuse /24, /25, /26 and /27 host counts.
Key takeaway
Count usable hosts — not total addresses — and remember that the network and broadcast addresses are not available to hosts in standard IPv4 subnets.
Real-world example
How this comes up in practice
A network engineer segments a warehouse floor into three subnets: 20 scanners, 5 printers, and 2 management hosts. Picking the wrong mask wastes addresses or leaves too few usable hosts. Exam questions test whether you can apply CIDR notation, calculate block size, and identify the correct usable-host range for a given prefix.
What to study next
Got this wrong? Here's your next step.
Review block sizes, usable host formulas (2^n − 2), and how to find network and broadcast addresses for /24 through /30. Then practise related 200-301 subnetting questions on CIDR, address ranges, and subnet selection.
Related practice questions
Related 200-301 practice-question pages
Use these pages to review the topic behind this question. This is how one missed question becomes focused revision.
CCNA subnetting practice questions
Practise IPv4 subnetting, CIDR, masks, host ranges and subnet selection.
CCNA OSPF practice questions
Practise OSPF neighbours, router IDs, metrics, areas and routing-table interpretation.
CCNA VLAN practice questions
Practise VLANs, access ports, trunks, allowed VLANs and switching scenarios.
CCNA STP practice questions
Practise spanning tree, root bridge election, port roles and STP troubleshooting.
CCNA EtherChannel practice questions
Practise LACP, PAgP, port-channel behaviour and bundle requirements.
CCNA ACL practice questions
Practise standard and extended ACLs, permit/deny logic and traffic filtering.
CCNA NAT practice questions
Practise static NAT, dynamic NAT, PAT and inside/outside address translation.
CCNA DHCP practice questions
Practise DHCP scopes, relay, leases and troubleshooting.
CCNA show ip route practice questions
Practise routing-table output, longest-prefix match, AD and route selection.
CCNA show interfaces trunk practice questions
Practise trunk verification and VLAN forwarding across switches.
CCNA wireless security practice questions
Practise WLAN security, authentication and wireless architecture concepts.
CCNA IPv6 practice questions
Practise IPv6 addressing, routes, neighbour discovery and common IPv6 exam traps.
Practice this exam
Start a free 200-301 practice session
Short sessions build daily habit. Longer sessions build exam-day stamina. Try a timed session to simulate real conditions.
FAQ
Questions learners often ask
What does this 200-301 question test?
CIDR notation defines the prefix length.
What exam trap should I watch out for?
Common exam trap: usable hosts are not the same as total addresses: Subnetting questions often tempt you into counting all addresses. In normal IPv4 subnets, the network and broadcast addresses are not usable host addresses.
What should I do if I get this 200-301 question wrong?
Review block sizes, usable host formulas (2^n − 2), and how to find network and broadcast addresses for /24 through /30. Then practise related 200-301 subnetting questions on CIDR, address ranges, and subnet selection.
What is the key concept behind this question?
CIDR notation defines the prefix length.
About these practice questions
Courseiva creates original exam-style practice questions with explanations and wrong-answer analysis. It does not publish real exam questions, exam dumps, or protected exam content. Learn why practice questions differ from exam dumps →
Keep practising
More 200-301 practice questions
- A router interface applies this ACL inbound: 10 deny tcp any any eq 80 20 permit ip any any A user reports that w…
- A switch has DHCP snooping enabled, but users still experience IP-to-MAC spoofing attacks. Which additional feature shou…
- Switch SW1 sends traffic for VLAN 30 across a trunk to SW2, but hosts in VLAN 30 on SW2 cannot communicate with hosts in…
- What problem is HSRP designed to solve?
- Which DHCP message does the client send to formally accept an offered address?
- What metric does RIP use to choose the best path?
Question Discussion
Share a tip, memory trick, or ask about the reasoning behind this question. Do not post real exam questions, leaked content, braindumps, or copyrighted exam material. Comments are moderated and may be removed without notice.
Sign in to join the discussion.
This 200-301 practice question is part of Courseiva's free Cisco certification practice question bank. Courseiva provides original exam-style practice questions with explanations, topic-based practice, mock exams, readiness tracking, and study analytics to help learners prepare for the 200-301 exam.