Simulate the real Cisco SPCOR / CCNP Service Provider Core 350-501 exam with full-length timed sessions. Questions drawn proportionally from all 8 official blueprint domains — the same mix you'll face on test day.
Cisco passing scores vary by exam version and are not always publicly listed. Check the official Cisco exam page before booking.
Simulate real exam conditions
For the most realistic 350-501 simulation, start a 60 or 120-question session, put away all notes, set a timer matching the real exam duration (120 minutes), and commit to each answer before moving forward. This trains the time management and decision-making skills the real exam tests.
This free 350-501 mock exam uses the same question distribution as the real Cisco SPCOR / CCNP Service Provider Core 350-501 exam. Each session draws questions proportionally from all 8 official blueprint domains published by Cisco, so the topic mix you see accurately reflects what you'll face on test day.
350-501 Domain Distribution
MPLS and Segment Routing
Automation and Quality of Services
Architecture
Networking
Security and Services
Automation and Quality of Service
Services
Automation and Assurance
Every question is written by certified engineers against the 2026 350-501 exam objectives. These are original practice questions — not dumps — so you build real understanding rather than memorising answers.
Both the mock exam and practice test use the same question bank. The difference is in how you use them — and when to use each during your 350-501 study plan.
Practice test — for learning
Use the 350-501 practice test when you are studying a domain. Answer questions, read every explanation immediately, and build understanding. Do 10–30 questions per domain per session. This is your primary study tool for the first 4 weeks.
Go to practice test →Mock exam — for simulation
Use the 350-501 mock exam in the final 1–2 weeks before your test date. Complete a 60 or 120-question session without stopping, manage your time, then review all results at the end. This builds exam-day stamina and surfaces final weak spots.
Start 120-question mock →Try these sample questions from the mock exam bank. Commit to an answer before revealing the explanation.
An engineer is troubleshooting an MPLS L3VPN where customers behind CE1 cannot reach a specific prefix behind CE2. The PE routers are using OSPF as the IGP and LDP for label distribution. On PE2, the prefix is present in the VRF routing table, but not in the VRF forwarding table. What is the most likely cause?
Select an answer to reveal the explanation
A service provider is designing a new MPLS core network using Segment Routing with MPLS data plane. They require traffic engineering capabilities to optimize bandwidth utilization. Which technology should be used to compute optimal paths based on IGP link attributes and bandwidth constraints?
Select an answer to reveal the explanation
In the DiffServ model, which DSCP value is used for Expedited Forwarding (EF) to support voice traffic?
Select an answer to reveal the explanation
A service provider is designing a new MPLS L3VPN service. The customer requires that their VPN traffic be isolated from other customers and that the provider edge routers maintain separate routing tables for each VPN. Which architectural component is essential for this separation?
Select an answer to reveal the explanation
A service provider is deploying MPLS L3VPN over an OSPF backbone. The PE routers are configured with OSPF as the IGP. The CE router of customer A is connected to two PEs for redundancy. Which configuration is required on the PE routers to ensure that the CE router can load-balance traffic across both PEs without loops?
Select an answer to reveal the explanation
An ISP is designing an MPLS core network and needs to choose an IGP that supports fast convergence. Which IGP meets this requirement and is most commonly used in MPLS core networks?
Select an answer to reveal the explanation
A network engineer is troubleshooting an MPLS L3VPN where the CE router is receiving the correct VPN prefixes from the PE, but traffic from the CE to those prefixes is being dropped. The PE has a default route pointing to the CE. What is the most likely cause?
Select an answer to reveal the explanation
A service provider is deploying segment routing in its MPLS core. Which label allocation method is used by segment routing to distribute prefix SIDs?
Select an answer to reveal the explanation
A service provider wants to protect its routers from CPU overload caused by excessive traffic to the control plane. Which mechanism should be configured on IOS XR routers to classify and rate-limit management traffic?
Select an answer to reveal the explanation
A service provider is implementing QoS on an MPLS network to support voice, video, and data traffic. Which queuing mechanism provides the lowest latency for real-time traffic?
Select an answer to reveal the explanation
A service provider is deploying MPLS Layer 3 VPN and needs to ensure that BGP next-hop resolution works correctly for VPNv4 prefixes learned from a route reflector. The PE routers are directly connected to the RR via iBGP, and there is an IGP running within the MPLS core. Which condition must be met for the PE to install the VPNv4 prefix into its routing table?
Select an answer to reveal the explanation
A service provider is designing a multicast solution for a Layer 3 VPN. They want to use MVPN with BGP signaling (draft-rosen). The PE routers are configured with VRF and multicast routing enabled. Which BGP address family must be enabled between PE routers to carry multicast routing information?
Select an answer to reveal the explanation
A network engineer is troubleshooting an MPLS TE tunnel that is not coming up. The tunnel is configured with a strict explicit path, and the path includes an interface that is currently down. Which action should the engineer take to allow the tunnel to use an alternative path?
Select an answer to reveal the explanation
A service provider is implementing network automation using YANG data models. They need to ensure that the automation solution supports both configuration and operational state data retrieval. Which NETCONF operation should be used to retrieve operational state data?
Select an answer to reveal the explanation
Which tool is used to validate YANG data models against device capabilities and to generate Python bindings for automation scripts?
Select an answer to reveal the explanation
Answer all 15 questions to see your domain score breakdown
Sitting the 350-501 under real exam conditions is a skill in itself. Candidates who underperform often do so not because of knowledge gaps, but because of poor time management or test anxiety. Use your final mock exam sessions to address both.
The 350-501 exam lasts 120 minutes. Do not spend more than 90 seconds on any single question on the first pass. Flag difficult ones and return to them after completing the rest.
On every question, immediately eliminate obviously wrong choices. Even if you are unsure between two options, narrowing to two doubles your odds. Most 350-501 distractors contain a subtle error — re-read the scenario constraint before committing to the answer that sounds most familiar.
Cisco writes many 350-501 questions as realistic scenarios. Read the final sentence first — it tells you what is being asked. Then re-read the scenario with the question in mind to avoid wasting time on irrelevant details.
The real 350-501 is a mental marathon lasting 120 minutes. In the week before your exam, complete at least two full timed mock sessions on separate days to build concentration stamina. If you cannot stay focused for 120 minutes in practice, you will struggle on exam day.
Questions
90
On the real exam
Time limit
120 min
1.3 min per question
Passing score
Variable
See vendor page
Cisco passing scores vary by exam version and are not always publicly listed. Check the official Cisco exam page before booking.
Yes. Courseiva provides free 350-501 mock exam questions across all official exam domains. The platform includes timed simulation, per-domain score breakdown, missed-question review, and readiness tracking. No account required — free forever, supported by advertising.
The practice test is optimised for learning: you see explanations after each question immediately. The mock exam is optimised for simulation: you answer all questions under time pressure and review at the end. Use practice tests for studying and mock exams for benchmarking.
Aim for consistent scores above 80% before booking your 350-501 exam. Strong mock-exam performance is a reliable indicator of readiness. Cisco passing scores vary by exam version and are not always publicly listed. Check the official Cisco exam page before booking.
Most candidates who pass 350-501 on their first attempt complete 3–5 full-length mock exams in the two weeks before their test. This is enough to identify final weak spots, build stamina, and verify readiness without over-stressing or running out of fresh questions.
No — all Courseiva questions are original, written by certified engineers against public Cisco exam blueprints. Exam dumps are memorised real exam questions shared illegally. Using dumps violates your Cisco certification agreement and can result in your certification being revoked. Our questions make you genuinely competent, not just test-day lucky.
Track your mock exam scores, see per-domain analytics, and benchmark readiness across every certification.
Sign Up FreeFree forever · Every certification included