C_S4EWM Extended Warehouse Management Practice Question
Exhibit
Config: /SCWM/ST_TYPE - Capacity Check Method: 4 (Warehouse Product). Product Master: Capacity usage: 50. Bin Master: Total capacity: 100. Current stock in bin: 60.
Refer to the exhibit. Can the system allow a new task for 30 units of the same product into this bin?
⚠ Common exam trap
Candidates often miscalculate total capacity by adding current units and new units incorrectly, or they confuse product quantity limits with maximum weight limits defined in other capacity check methods.
Answer choices
Why each option matters
Answer the question above first, then reveal the full breakdown to understand why each option is right or wrong.
Correct answer & explanation
✓
Yes, because the combined load (90) is less than the bin's limit (100).
The capacity check method '4' (Warehouse Product) uses the product's defined capacity consumption and compares it against the bin's total capacity. With 60 units already in the bin, and each unit consuming 1 capacity, the bin is at 60/100. Adding 30 units would bring the total to 90/100. Since 90 is less than 100, the system allows the task to be created and executed.
Answer analysis
Option-by-option breakdown
For each option: why learners choose it and why it is or isn't the right answer here.
- ✗
No, because the bin is already at 60% capacity.
Why it's wrong here
The capacity check evaluates the remaining available capacity against the incoming task's requirements. Being at 60% capacity does not automatically block a new task if the total planned load stays under 100%. The system performs a dynamic validation check, not a static percentage-based block.
- ✓
Yes, because the combined load (90) is less than the bin's limit (100).
Why this is correct
The calculation is straightforward: current load (60) plus new load (30) equals 90. Since the maximum bin capacity is 100, the new load is within the allowed limit. The system's capacity check logic will validate this and permit the warehouse task creation successfully.
- ✗
No, because the system always uses a 50% threshold.
Why it's wrong here
EWM does not have a hard-coded 50% capacity threshold for all bins. The capacity limit is defined in the bin master data, and the check method determines how that limit is utilized. The system evaluates the specific math of the current load versus the limit defined.
- ✗
Yes, but only if the warehouse process type is set to 'Immediate'.
Why it's wrong here
Capacity check logic is independent of the warehouse process type timing. Whether the task is immediate or deferred, the system checks the capacity limits during the task creation step. The 'Immediate' flag affects when the task is visible, not the fundamental capacity validation logic.
About these practice questions
This C_S4EWM question is part of Courseiva's 217-question bank — original exam-style content with full explanations and wrong-answer analysis, never real exam questions or exam dumps. Learn why practice questions differ from exam dumps →
JA
Written and reviewed by Johnson Ajibi, MSc IT Security
Senior Network & Security Engineer · founder of Courseiva
Last reviewed September 2026 · checked against the official SAP exam blueprint
This C_S4EWM practice question is part of Courseiva's free SAP certification practice question bank. Courseiva provides original exam-style practice questions with explanations, topic-based practice, mock exams, readiness tracking, and study analytics to help learners prepare for the C_S4EWM exam.