C_S4EWM Extended Warehouse Management Practice Question

Answer analysis

Option-by-option breakdown

For each option: why learners choose it and why it is or isn't the right answer here.

• ✓

  The storage type's putaway rule 'E' (Empty bin) is used, but the storage section search is restricted to a section that has no empty bins.

  Why this is correct

  When the putaway rule 'E' is used, the system searches for empty bins within the storage sections determined by the storage section search. If the storage section search is limited to a section with no empty bins, the system will not find any, even if other sections have empty bins. This is a common configuration issue where the storage section indicator or search sequence restricts the search area.

• ✗

  The storage bin's 'Bin Status' is set to 'Blocked' for all empty bins.

  Why it's wrong here

  If all empty bins were blocked, the system would indeed not find them. However, the scenario states that empty bins exist; it does not specify their status. Blocking all empty bins is unlikely and would be an extreme measure. Moreover, the system typically excludes blocked bins from search, but the more common cause is a restriction in the search area. This option is less likely because it would require all empty bins to be blocked, which is not typical.

• ✗

  The storage type's 'Putaway Control Indicator' does not allow empty bin search.

  Why it's wrong here

  The putaway control indicator determines the putaway rule, but if it did not allow empty bin search, the system would not use rule 'E'. However, the scenario implies that rule 'E' is intended. The putaway control indicator is a higher-level setting that can override the storage type's rule, but if it were set incorrectly, the system might not search for empty bins at all. This is possible but less specific than a storage section search restriction.

• ✗

  The storage type's putaway rule is set to 'F' (Fixed bin) instead of 'E' (Empty bin).

  Why it's wrong here

  If the putaway rule were 'F' (Fixed bin), the system would only consider fixed bins assigned to the product, not general empty bins. However, the scenario states that empty bins exist but are not found, which could still happen with fixed bin if the product has no fixed bin. But the key is that the rule might be misconfigured; however, the more specific cause is that the storage section search is restricted. This option is plausible but not the most likely because fixed bin would not normally search for empty bins at all, and the issue is that empty bins exist and are not found, pointing to a restriction.