Courseiva
← 300-410
Full test
mediumDrag & DropObjective-mapped

300-410 Practice Question: Drag and drop the steps to configure and verify…

Drag and drop the steps to configure and verify Policy-Based Routing (PBR) into the correct order, from first to last.

Drag steps to the numbered slots on the right, or tap a step then tap a slot.

Steps
Order
1Step 1
2Step 2
3Step 3
4Step 4
5Step 5

Answer choices

Why each option matters

Answer the question above first, then reveal the full breakdown to understand why each option is right or wrong.

Correct answer & explanation

✓

Create route map with sequence number

First, define the route map with a sequence number. Next, match the interesting traffic using an ACL or prefix list. Then, set the next-hop or interface. Apply the route map under the interface in the inbound direction. Finally, verify with 'show route-map' or 'show ip policy'.

Visual reference

Source Router + ACL permit 10.0.0.0/8 deny any Server 10.0.0.5 ✓ 192.168.1.1 ✗ dropped ACLs evaluate top-down; first match wins — implicit deny all at end

About these practice questions

This 300-410 question is part of Courseiva's 1,966-question bank — original exam-style content with full explanations and wrong-answer analysis, never real exam questions or exam dumps. Learn why practice questions differ from exam dumps →

How Courseiva writes practice questions · Editorial policy

Same concept, more angles

1 more way this is tested on 300-410

These questions test the same concept from different angles. Work through them to make sure you can recognise it however the exam phrases it.

Variation 1. Which TWO configuration steps are required to implement Policy-Based Routing (PBR) on a Cisco router? (Choose TWO.)

easy
  • ✓ A.Create a route-map with match and set commands.
  • ✓ B.Apply the route-map to an interface using the 'ip policy route-map' command.
  • C.Configure an access-list to match the traffic.
  • D.Enable CEF globally.
  • E.Use the 'ip local policy route-map' command.

Why A: To implement PBR, you must create a route-map with match and set commands, then apply it to an interface using 'ip policy route-map'. Configuring an ACL is optional if match criteria use other methods. Enabling CEF is not required for PBR. The 'ip route' command is for static routing, not PBR. 'ip local policy route-map' is only for locally generated packets, not a general requirement.

JA

Written by Johnson Ajibi, MSc IT Security

Senior Network & Security Engineer · founder of Courseiva

This 300-410 practice question is part of Courseiva's free Cisco certification practice question bank. Courseiva provides original exam-style practice questions with explanations, topic-based practice, mock exams, readiness tracking, and study analytics to help learners prepare for the 300-410 exam.