350-701 Practice Question: Drag and drop the steps to implement Cisco…

Drag and drop the steps to implement Cisco Umbrella (formerly OpenDNS) for DNS-layer security in the correct order.

Drag steps to the numbered slots on the right, or tap a step then tap a slot.

Steps

Order

1Step 1

2Step 2

3Step 3

4Step 4

5Step 5

Answer choices

Why each option matters

Answer the question above first, then reveal the full breakdown to understand why each option is right or wrong.

Correct answer & explanation

✓

Registration, Add network identity, Point DNS to Umbrella, Set policies, Verify

Start with registration, add network identity, point DNS to Umbrella, set policies, then verify.

Answer analysis

For each option: why learners choose it and why it is or isn't the right answer here.

✓
Registration, Add network identity, Point DNS to Umbrella, Set policies, Verify
Why this is correct
This is the correct order because you must first register an account, then add your network identity (e.g., network IP or AD connector), then configure DNS to point to Umbrella's resolvers, then apply security policies, and finally verify everything is working.
✗
Registration, Point DNS to Umbrella, Add network identity, Set policies, Verify
Why it's wrong here
This order is incorrect because you should add the network identity before pointing DNS to Umbrella; otherwise, the DNS changes may not be properly associated with your network.
✗
Add network identity, Registration, Point DNS to Umbrella, Set policies, Verify
Why it's wrong here
This order is incorrect because registration must occur first to establish the account before you can add any network identity.
✗
Registration, Add network identity, Set policies, Point DNS to Umbrella, Verify
Why it's wrong here
This order is incorrect because policies should be set after pointing DNS to Umbrella; otherwise, the policies would have no effect until DNS is redirected.

Go deeper