Free · No account needed · No credit card

Cisco DCCOR / CCNP Data Center Core 350-601 Practice Test

500 questions with instant explanations, domain breakdown, and wrong-answer analysis. Built for the real exam.

Instant feedback after each answer
Full explanations included
Domain score breakdown
Real exam: 120 min
Pass mark: 753%

Sample questions with explanations

This is exactly what you see during practice — question, options, and a full explanation after you answer.

Q1Storage Networkeasy
Full explanation →

An engineer is configuring a Fibre Channel over Ethernet (FCoE) SAN. Which statement about FCoE Initialization Protocol (FIP) is true?

AFIP operates only over lossless Ethernet.
FIP uses Ethernet MAC addresses for communication.Correct
CFIP is used only for FCoE initialization, not for maintenance.
DFIP requires IP addresses to establish FCoE sessions.

FCoE Initialization Protocol (FIP) uses Ethernet MAC addresses for communication during the discovery, initialization, and maintenance phases of an FCoE session. FIP frames are encapsulated in standard Ethernet frames with a specific EtherType (0x8914), allowing FCoE-capable endp…Read full explanation

Q2Storage Networkmedium
Full explanation →

A storage administrator needs to ensure that a Fibre Channel zone configuration is operationally effective without disrupting the current active zone set. Which approach should be used?

Create the new zone configuration in the defined configuration, then activate it as a new zone set.Correct
BDelete the active zone set and create a new one.
CEdit the active zone set directly.
DUse the 'commit' command to update the zone set.

Option A is correct because in Cisco MDS Fibre Channel SANs, zone configurations are created in the defined configuration and then activated as a new zone set. This approach ensures that the current active zone set remains operational and unaffected during the configuration proce…Read full explanation

Q3Storage Networkhard
Full explanation →

A data center deployment uses NPV mode on a Cisco MDS switch to connect to a core Fibre Channel switch. After configuration, the NPV switch does not register with the core. What is the most likely cause?

AFibre Channel ports are in trunk mode.
BThe core switch has NPV mode enabled.
NPIV is not enabled on the core switch.Correct
DThe NPV switch has an incorrect domain ID.

NPV (N_Port Virtualization) mode requires NPIV (N_Port ID Virtualization) to be enabled on the core Fibre Channel switch. NPIV allows a single physical N_Port to register multiple FCIDs (Fibre Channel IDs) for multiple virtual initiators behind the NPV switch. Without NPIV on the…Read full explanation

Untimed Practice

Answer at your own pace. Explanation and domain tag shown immediately after each answer.

Timed Practice

Countdown timer starts immediately. Results and domain scores shown at the end — just like the real exam.

Why practice here?

Full explanations on every question

Not just the right answer — you get exactly why each wrong option is wrong, so you learn the concept, not the answer.

Domain score breakdown

After each session see your score by exam domain so you know exactly where to focus study time.

100% free, forever

No subscription, no trial, no email wall. Start a session in under 10 seconds.

Exam-style questions

Scenario-based, precise wording, realistic distractors — written to match what you actually see on exam day.

← All 350-601 questions350-601 exam guideStudy guidePractice by domain