- A
The interface will not send DTP frames, but will still respond to incoming DTP frames.
Why wrong: Incorrect. 'nonegotiate' disables both sending and processing of DTP frames.
- B
The interface will not send or process DTP frames, and remains a trunk.
Correct. DTP is completely disabled, and the static trunk configuration remains.
- C
The interface will revert to an access port.
Why wrong: Incorrect. The 'switchport mode trunk' command still applies; 'nonegotiate' only affects DTP.
- D
The interface will negotiate trunking using ISL instead of DTP.
Why wrong: Incorrect. 'nonegotiate' disables negotiation entirely; it does not switch protocols.
CCNP VLANs and Trunking Practice Question
This 350-401 practice question tests your understanding of vlans and trunking. This is a configuration task: choose the command set that satisfies every stated requirement. Small differences — like 'secret' vs 'password' or 'transport input ssh' vs 'all' — change whether the answer is correct. After answering, compare your reasoning against the explanation and wrong-answer breakdown below. Once you have made your selection, read the full explanation to reinforce the concept and understand why each distractor is designed to mislead on exam day.
Examine the following configuration on a Cisco IOS-XE switch:
interface GigabitEthernet0/5 switchport mode trunk switchport trunk native vlan 999 switchport trunk allowed vlan 10,20,30 switchport nonegotiate
What is the effect of the 'switchport nonegotiate' command?
Answer choices
Why each option matters
Answer the question above first, then reveal the full breakdown to understand why each option is right or wrong.
Correct answer & explanation
The interface will not send or process DTP frames, and remains a trunk.
The 'switchport nonegotiate' command disables Dynamic Trunking Protocol (DTP) on the interface. When configured on a trunk port, the interface will neither send nor process any DTP frames, ensuring the port remains in trunk mode regardless of the neighbor's DTP configuration. This is commonly used when connecting to non-Cisco devices that do not support DTP, or to prevent unwanted trunk negotiation.
Key principle: Answer the scenario, not the keyword: identify the specific constraint before choosing the most familiar-sounding option.
Answer analysis
Option-by-option breakdown
For each option: why learners choose it and why it is or isn't the right answer here.
- ✗
The interface will not send DTP frames, but will still respond to incoming DTP frames.
Why it's wrong here
Incorrect. 'nonegotiate' disables both sending and processing of DTP frames.
- ✓
The interface will not send or process DTP frames, and remains a trunk.
- ✗
The interface will revert to an access port.
- ✗
The interface will negotiate trunking using ISL instead of DTP.
Why it's wrong here
Incorrect. 'nonegotiate' disables negotiation entirely; it does not switch protocols.
Common exam traps
Common exam trap: answer the scenario, not the keyword
Cisco often tests the misconception that 'switchport nonegotiate' only stops sending DTP frames but still allows the interface to respond to them, when in fact it disables all DTP processing, both sending and receiving.
Trap categories for this question
Command / output trap
Incorrect. The 'switchport mode trunk' command still applies; 'nonegotiate' only affects DTP.
Detailed technical explanation
How to think about this question
DTP is a Cisco proprietary protocol that runs on trunk ports to negotiate trunking status and encapsulation (ISL or 802.1Q). When 'switchport nonegotiate' is applied, the interface stops sending DTP frames (which are multicast frames with destination MAC 01-00-0C-CC-CC-CC) and ignores any received DTP frames, effectively making the port statically trunked. This is critical when connecting to non-Cisco switches or hosts that might misinterpret DTP frames, potentially causing a trunk to form unintentionally or a port to become err-disabled.
KKey Concepts to Remember
- Read the scenario before looking for a memorised answer.
- Find the constraint that changes the correct option.
- Eliminate answers that are true in general but not in this case.
TExam Day Tips
- Watch for words such as best, first, most likely and least administrative effort.
- Review why wrong options are wrong, not only why the correct option is correct.
Key takeaway
Answer the scenario, not the keyword: identify the specific constraint before choosing the most familiar-sounding option.
Real-world example
How this comes up in practice
A network engineer at a university connects two campus buildings via a fibre link. Both routers run OSPF, but no adjacency forms — even though both routers can ping each other. The engineer finds one router is in area 0 and the other in area 1. OSPF adjacency requires matching area numbers, hello/dead timers, and network type. IP reachability alone is not enough.
What to study next
Got this wrong? Here's your next step.
Identify which exam domain this question belongs to, review the core concept, then practise similar questions from the same domain.
- →
VLANs and Trunking — study guide chapter
Learn the concepts, then practise the questions
- →
VLANs and Trunking practice questions
Targeted practice on this topic area only
- →
All 350-401 questions
2,015 questions across all exam domains
- →
ENCOR 350-401 study guide
Full concept coverage aligned to exam objectives
- →
350-401 practice test guide
How to use practice tests most effectively before exam day
Related practice questions
Related 350-401 practice-question pages
Use these pages to review the topic behind this question. This is how one missed question becomes focused revision.
Architecture practice questions
Practise 350-401 questions linked to Architecture.
Enterprise Network Design practice questions
Practise 350-401 questions linked to Enterprise Network Design.
SD-Access Architecture practice questions
Practise 350-401 questions linked to SD-Access Architecture.
SD-WAN Architecture practice questions
Practise 350-401 questions linked to SD-WAN Architecture.
QoS Architecture practice questions
Practise 350-401 questions linked to QoS Architecture.
Virtualization practice questions
Practise 350-401 questions linked to Virtualization.
Network Function Virtualization practice questions
Practise 350-401 questions linked to Network Function Virtualization.
Virtual Machines and Hypervisors practice questions
Practise 350-401 questions linked to Virtual Machines and Hypervisors.
VRF and Path Isolation practice questions
Practise 350-401 questions linked to VRF and Path Isolation.
Infrastructure practice questions
Practise 350-401 questions linked to Infrastructure.
OSPF practice questions
Practise 350-401 questions linked to OSPF.
BGP practice questions
Practise 350-401 questions linked to BGP.
Practice this exam
Start a free 350-401 practice session
Short sessions build daily habit. Longer sessions build exam-day stamina. Try a timed session to simulate real conditions.
FAQ
Questions learners often ask
What does this 350-401 question test?
VLANs and Trunking — This question tests VLANs and Trunking — Read the scenario before looking for a memorised answer..
What is the correct answer to this question?
The correct answer is: The interface will not send or process DTP frames, and remains a trunk. — The 'switchport nonegotiate' command disables Dynamic Trunking Protocol (DTP) on the interface. When configured on a trunk port, the interface will neither send nor process any DTP frames, ensuring the port remains in trunk mode regardless of the neighbor's DTP configuration. This is commonly used when connecting to non-Cisco devices that do not support DTP, or to prevent unwanted trunk negotiation.
What should I do if I get this 350-401 question wrong?
Identify which exam domain this question belongs to, review the core concept, then practise similar questions from the same domain.
What is the key concept behind this question?
Read the scenario before looking for a memorised answer.
About these practice questions
Courseiva creates original exam-style practice questions with explanations and wrong-answer analysis. It does not publish real exam questions, exam dumps, or protected exam content. Learn why practice questions differ from exam dumps →
Keep practising
More 350-401 practice questions
- Drag and drop the steps to configure an extended access control list (ACL) on a Cisco router in the correct order.
- Drag and drop the steps to configure a site-to-site IPsec VPN on a Cisco router in the correct order.
- Drag and drop the steps to configure VLAN Trunking Protocol (VTP) on a Cisco switch in the correct order.
- Drag and drop the steps to configure a static route on a Cisco IOS router into the correct order.
- Drag and drop the steps to configure port security on a Cisco switch in the correct order.
- Drag and drop the steps for the Spanning Tree Protocol (STP) convergence process in the correct order.
Last reviewed: Jun 24, 2026
This 350-401 practice question is part of Courseiva's free Cisco certification practice question bank. Courseiva provides original exam-style practice questions with explanations, topic-based practice, mock exams, readiness tracking, and study analytics to help learners prepare for the 350-401 exam.
Question Discussion
Share a tip, memory trick, or ask about the reasoning behind this question. Do not post real exam questions, leaked content, braindumps, or copyrighted exam material. Comments are moderated and may be removed without notice.
Sign in to join the discussion.