Question 1hardmultiple choice
Full question →hardmultiple choiceObjective-mapped
A small office network uses a router (192.168.1.1/24) and an unmanaged switch. A technician configures a server with a static IP address 192.168.1.100/24, gateway 192.168.1.1, and connects it to the switch. Workstations on the same subnet can ping the router (192.168.1.1) but cannot ping the server. The server can ping its own IP and the router. Which of the following is the MOST likely cause?
Answer choices
Why each option matters
Good practice is not just finding the correct option. The wrong answers often show the exact trap the exam wants you to fall into.
A
Distractor review
The server has a duplicate IP address
A duplicate IP address would cause network conflicts, but the server can still ping the router. Typically, neither device would have reliable connectivity. Since the server can ping the router, a duplicate is less likely.
B
Distractor review
The switch port is administratively disabled
If the switch port were disabled, the server would not be able to communicate at all. The server can ping the router, so the switch port is operating.
C
Best answer
The server's firewall is blocking ICMP
A firewall, especially the default Windows Firewall, often blocks incoming ping requests by default. This prevents workstations from reaching the server while still allowing the server to send outbound traffic (like pinging the router).
D
Distractor review
The default gateway is incorrect
If the default gateway were incorrect, the server would not be able to ping the router. Since the server can ping 192.168.1.1, the gateway setting is correct.
Common exam trap
Common exam trap: usable hosts are not the same as total addresses
Subnetting questions often tempt you into counting all addresses. In normal IPv4 subnets, the network and broadcast addresses are not usable host addresses.
Technical deep dive
How to think about this question
Subnetting questions test whether you can identify the network, broadcast address, usable range, mask and correct subnet. Slow down enough to calculate the block size correctly.
KKey Concepts to Remember
- CIDR notation defines the prefix length.
- Block size helps identify subnet boundaries.
- Network and broadcast addresses are not usable hosts in normal IPv4 subnets.
- The required host count determines the smallest suitable subnet.
TExam Day Tips
- Write the block size before choosing the subnet.
- Check whether the question asks for hosts, subnets or a specific address range.
- Do not confuse /24, /25, /26 and /27 host counts.
Related practice questions
Related 220-1101 practice-question pages
Use these pages to review the topic behind this question. This is how one missed question becomes focused revision.
CompTIA A+ hardware practice questions
Practise 220-1101 questions linked to CompTIA A+ hardware.
CompTIA A+ mobile devices practice questions
Practise 220-1101 questions linked to CompTIA A+ mobile devices.
CompTIA A+ networking practice questions
Practise 220-1101 questions linked to CompTIA A+ networking.
CompTIA A+ operating systems practice questions
Practise 220-1101 questions linked to CompTIA A+ operating systems.
CompTIA A+ security practice questions
Practise 220-1101 questions linked to CompTIA A+ security.
CompTIA A+ software troubleshooting questions
Practise 220-1101 questions linked to CompTIA A+ software troubleshooting questions.
CompTIA A+ operational procedures questions
Practise 220-1101 questions linked to CompTIA A+ operational procedures questions.
More questions from this exam
Keep practising from the same exam bank, or move into a focused topic page if this question exposed a weak area.
Question 1
A user reports intermittent network connectivity on a desktop computer. The technician observes that the Ethernet link light on the NIC turns off for a few seconds and then turns back on. The cable passes a wiremap test, the switch port is verified good with another device, and the NIC driver is updated. The issue occurs more frequently when the computer's case fan runs at high speed. Which of the following is the MOST likely cause?
Question 2
A workstation is unable to connect to the internet. The technician runs the 'ipconfig' command and sees the IPv4 address is 169.254.15.200 with a subnet mask of 255.255.0.0. The workstation can ping other devices on the local subnet but cannot ping the default gateway or any external addresses. Which TWO actions should the technician take to resolve this issue? (Select two.)
Question 3
A workstation is connected to a managed switch. It obtains a valid IP address (192.168.10.50) from the DHCP server, but it cannot ping the default gateway (192.168.10.1). The link light on both the workstation NIC and the switch port are solid green. Other workstations on the same switch CAN ping the default gateway successfully. The technician accesses the switch management interface and finds that the workstation's port is configured as an access port on VLAN 10. The default gateway is located on VLAN 20. An inter-VLAN router is configured but not explicitly allowing VLAN 10 access to VLAN 20. Which of the following is the MOST likely cause of the problem?
Question 4
A company develops a web application that relies on a custom library available only for a specific Linux distribution. They want to deploy the application in the cloud with minimal administrative overhead, but they need full control over the software stack, including the ability to install the custom library and configure the web server. Which cloud service model BEST meets these requirements?
Question 5
A company has a legacy virtual machine running on a deprecated hypervisor (Hyper-V). They want to migrate this VM to a new hypervisor (VMware vSphere) hosted in a private cloud while preserving the VM's configuration, installed applications, and data. The migration must be performed with minimal downtime. Which of the following methods is MOST appropriate?
Question 6
A company hosts a critical database on a virtual machine in a public cloud. The database requires persistent storage that must be retained even if the VM is terminated. The storage must also be accessible from multiple VMs simultaneously for a future high-availability configuration. Which type of cloud storage BEST meets these requirements?
FAQ
Questions learners often ask
What does this 220-1101 question test?
CIDR notation defines the prefix length.
What is the correct answer to this question?
The correct answer is: The server's firewall is blocking ICMP — The server can communicate with the router, indicating that its IP configuration and physical connectivity are correct. The fact that other workstations cannot ping the server suggests the server is not responding to ICMP (ping) requests. The most common reason is that the server's firewall is blocking inbound ICMP. A duplicate IP would cause intermittent issues and the server might not be able to ping the router reliably. A disabled switch port would prevent all traffic to and from the server. An incorrect gateway would prevent the server from reaching the router.
What should I do if I get this 220-1101 question wrong?
Then try more questions from the same exam bank and focus on understanding why the wrong options are tempting.
Discussion
Loading comments…
Sign in to join the discussion.